Danby DKC644BLS Owner's Manual download pdf (Page 15)

Close the main cylinder valve (A) by turning in a

clockwise direction. See Fig.12

Close the secondary shut-off valve (C) by

turning to "horizontal" (east/west) position on

lower stem pipe. See Fig.12

Remove the air line clamp and hose from the

regulator.

Remove the regulator assembly (E) from empty

cylinder. See Fig.12

Remove dust cap from new and/or replacement

CO 2 cylinder

Re-attach regulator assembly (E) to

new/replacement cylinder. See Fig.12

Re-attach the air line hose to regulator (barb

connection) and secure with clamp.

Slowly open main valve (A) all the way.

See Fig. 12

9. Readjust regulator pressure (D) (if necessary)

between 10 - 12 psi/Ibs.

10. Open the secondary shut-off valve (C)by turning

to "vertical" (north/south) position on lower stem

pipe.

Fig. 12

• Prior to tapping the keg, ensure the beer faucet is in

the off position.

,, Completely remove the dust cover (identification cap)

from the beer keg.

Check that the keg coupler (handle) is in the up (off)

position. See Fig. 8

,, Insert the keg coupler into the locking neck of the beer

keg and apply a turn clockwise to lock into position.

,, Pull keg coupler handle out and downward until it locks

into position. See Fig. 9 This activates both the beer and

(CO2) pressure line.

The keg is now tapped and ready to draw beer.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

No comments

Danby DKC644BLS Owner's Manual Page 15