Danby DKC644BLS Owner's Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 21
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
ASSEMBLY INSTRUCTIONS (CONT'D)
.
Installation of C02 Air Line Hose to Regulator:
Attach one end of the (red) air line hose to the
hose barb connection on the CO 2 regulator.
Secure hose by using one of the two (self locking)
black plastic snap on clamps provided. (use pliers
to snap the clamp tight to assure that there are
no leaks) See Fig. 5
8. installation of the BeerTower Gasket: Position
the rubber (beer tower) gasket directly on top
of the cabinet aligning all four holes in the
gasket with the four holes on the cabinet.
. Installation of the Beer Tower: Unravel the beer
line (hose) from the tower and insert the beer
line and nut through the gasket and into the
cabinet. Align the four holes in the base of the
beer tower, gasket and bayonet. The beer faucet
should be facing the front of the cabinet. (6:00
o'clock position) Using a Phillips Screwdriver,
attach the beer tower to the cabinet using the four
machine screws provided and tighten firmly.
10. Installation of the Beer Tower Faucet Handle:
Screw the black faucet handle (clockwise) onto
the beer tower faucet. (hand tighten only)
Fig. 5 Fig. 6 Fig. 7
11. Protective Plate (Pro=installed): To prevent
unnecessary damage (marring) to the floor of
the refrigerator cabinet, the protective plate
should always be installed when the keg stand
is being used. The protective plate also makes
installation and removal of the keg and keg
stand easier.
12. Installation of the Beer Keg: Position the keg
stand directly in front of the open refrigerator
cabinet. Using proper lifting technique, (using
keg handles only) carefully lift the beer keg onto
the keg stand. See Fig. 8
NOTE: The keg stand is required when
using 30 Liter (1/4 barrel) "pony" style kegs only.
To install the beer keg and stand inside the
refrigerator cabinet, brace your knees behind
the keg stand and grasp the keg stand handles.
Lift the front of the keg stand just enough so
that the front edge of the stand is resting on the
front edge of the refrigerator cabinet. See Fig. 9
Grasp the keg stand (front) handles and "care
fully" slide the keg stand all the way into the
refrigerator cabinet.
11
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Comments to this Manuals

No comments