Danby DDW2405BL Owner's Manual download pdf (Page 4)

PREPARE ELECTRICAL WIRING

WARNING:

FOR PERSONAL SAFETY:

Remove house fuse or open circuit

breaker before beginning installation.

Do not use an extension cord or adapter

plug with this appliance.

Electrical Requirements:

• This appliance must be supplied with 120V / 60 Hz.,

and connected to an individual properly grounded

branch circuit, protected by a 15 or 20 ampere circuit

breaker or time delay fuse.

• Wiring must be two wire with ground.

• If the electrical supply does not meet the above

requirements, call a licensed electrician before

proceeding.

Grounding Instructions

This appliance must be connected

to a grounded metal, permanent wiring system, or an

equipment grounding conductor must be run with the

circuit conductors and be connected to the equipment

grounding terminal or lead on the appliance.

WARNING:

Improper connection of the equipment

grounding conductor can result in a risk

of electric shock. Check with a qualified

electrician or service representative if

you are in doubt that the appliance is

properly grounded.

Cabinet Preparation & Wire Routing:

• The wiring may enter the opening from either

side, rear or the floor within the shaded area.

• Cut a 1-1/2” max. dia. hole to admit the electrical

cable. The hole must be free of sharp edges. If

the cabinet wall is metal, the hole edge must be

covered with a bushing/grommet.

• Cable direct connections may pass through the

same hole as the drain hose and hot water line,

if convenient.

Electrical Connection to Dishwasher:

• The electrical connection is located on the right

front side of the dishwasher.

• The cable must be routed as shown in Fig. 5

Cable must extend a minimum of 24” from the

rear wall.

INSTALLATION PREPARATION

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Danby DDW2405BL Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Dishwashers Danby DDW2405BL