Danby DDW2405BL Owner's Manual download pdf (Page 11)

STEP 13 CONNECT POWER SUPPLY

• Remove junction box Cover “ A “.

• Locate the three dishwasher wires, (white, black and

green) with stripped ends. Insert dishwasher wires

through the small hole in the junction Box “ B “.

• Secure house wiring to the bottom of the junction box

with a strain relief “ C “.

• Use wire nuts to connect incoming ground to green,

white to white and black to black “ D “.

• Replace junction box cover “ E “, check to be sure that

wires are not pinched under the cover.

WARNING

If house wiring is not 2-wire with

ground, a ground must be provided

by installer. When house wiring is

aluminum, be sure to use UL listed

antioxidant compound and aluminum

to copper connectors.

STEP 14 PRE-TEST CHECK LIST

Review this list after installing your dishwasher

to avoid charges for a service call that is not

covered by your warranty.

Check to be sure Power is OFF.

Open door and remove all foam and paper

packaging.

Locate the Owners manual in the literature

package.

Read the Owners manual for operating instruc-

tions.

Check door opening and closing. If door does

not open and close freely or tends to fall,

check spring adjustments. See Step 1.

Check to be sure that wiring is secure under

the dishwasher, not pinched or in contact with

door springs or other components. See Step

Check door alignment with tub. If door hits

tub, level dishwasher. See Step 10.

Pull lower rack out, about halfway. Check to

be sure it does not roll backward or forward on

to the door. If the rack moves, adjust leveling

legs. See Step 10.

Check door alignment with cabinet. If door hits

cabinet, reposition or re-level dishwasher. See

Step 10.

Verify water supply and drain lines are not

kinked or in contact with other components.

Contact with motor or dishwasher frame could

cause noise. See Step 8.

Turn on the sink hot water faucet and verify

water temperature. Incoming water tempera-

ture must be between 49

C (120

F) and

65.5

C (150

F). A minimum of 49

C tempera-

ture is required for best wash performance.

See “ Prepare Hot Water Line”, page 4.

Add two quarts of water to the bottom of the

dishwasher to lubricate the pump seal.

Turn on water supply. Check for leaks. Tighten

connections if needed.

Remove protective film if present from the con-

trol panel and door.

INSTALLATION INSTRUCTIONS

1 2 ... 6 7 8 9 10 11 12

Comments to this Manuals

No comments

Danby DDW2405BL Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Dishwashers Danby DDW2405BL