Danby DDW2405BL Owner's Manual download pdf (Page 10)

STEP 12 CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES

AND ORDINANCES

The drain hose molded end will fit 5/8”, 3/4” or 1”

diameter connections on the air gap, waste tee or

disposer. Cut the marked line as required for your

installation.

• If a longer drain hose is required, add up to 42”

length for a total of 10ft. to the factory installed

hose. Use 5/8” or 7/8” inside diameter hose and

a coupler to connect two hose ends. Secure the

connection with hose clamps.

• Secure the drain hose to the air gap, waste

tee or disposer with clamps.

NOTE:

TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED

10 FEET FOR PROPER DRAIN OPERATION.

DRAIN LINE INSTALLATION

• Connect drain line to air gap, waste tee or disposer

using either of the previously determined method.

Method 1 - Air gap with waste tee or disposer

Method 2 - High drain loop with waste tee or disposer

IMPORTANT -

When connecting the drain line to

the disposer, check to be sure that

the drain plug has been removed.

DISHWASHER WILL NOT DRAIN IF

PLUG IS LEFT IN PLACE.

TIP: Avoid unnecessary service call charges. Always

be sure disposer drain plug has been removed before

attaching dishwasher drain hose to dispenser.

INSTALLATION INSTRUCTIONS

1 2 ... 5 6 7 8 9 10 11 12

No comments

Danby DDW2405BL Owner's Manual Page 10