Danby DDW2405BL Owner's Manual download pdf (Page 3)

INSTALLATION PREPARATION

PREPARE DISHWASHER ENCLOSURE

• The dishwasher must be installed so that the

drain hose is no more than 10 feet in length for

proper drainage.

• The dishwasher must be fully enclosed on the

top, side and back, and must not support any

part of the enclosure.

Plumbing and

Electric Service

Must Enter

Shaded Area

• The rough cabinet opening must be at least

24” deep and to 24” wide. The opening

should be to 35” max height.

CLEARANCES: When

installed into a corner,

allow 2” min. clearance

between dishwasher and

adjacent cabinet, wall or

other appliances. Allow

25-5/8” min. clearance

from the front of the dish-

washer for the door

opening. Fig. 2

Method 1 Air Gap with Waste Tee or disposer

Method 2 High Drain with Waste

Tee or Disposer

Provide a method to attach drain hose to

underside of countertop.

2

DRAIN REQUIREMENTS:

• Follow local codes and ordinances.

• Do not exceed 10 feet in distance to the drain.

• Do not connect drain lines from other devices

to the dishwasher drain hose.

• Dishwasher must be connected to waste line

with an air gap (not supplied) or 32” minimum

high drain loop, depending on local codes and

ordinances to prevent back flow into the dish-

washer. Air gap must be used if waste tee or

disposer connection is less than 18” above the

floor to prevent siphoning.

DRAIN PREPARATION:

The type of drain installation depends on answers

to the following questions:

Do local codes or ordinances require installation

of an air gap?

Will waste tee or disposer connection be less

than 18” above the floor?

If the answer to ANY of the 2 questions above is

YES, METHOD 1 MUST BE USED. Otherwise

either Method 1 or Method 2 may be used.

Fig. 3 or Fig. 4

CAUTION:

An air gap MUST BE USED if the drain hose is

connected to waste tee or disposer lower than 18”

above the floor.

Failure to provide the proper drain connection

height with an air gap or 32” minimum high

drain loop will result in improper draining of

the dishwasher.

CABINET PREPARATION:

• Drill a 1-1/2” dia. hole in the cabinet wall within the

shaded areas shown in Fig. 1 for drain hose

connection. The hole should be smooth with no

sharp edges.

Floor must be

even with

room floor.

1 2 3 4 5 6 7 8 ... 11 12

Comments to this Manuals

No comments