Danby DDW1804EW Owner's Manual download pdf (Page 5)

INSTALLATION INSTRUCTIONS

Connecting the hot water line

Run the hot water line through the channel on the

bottom left side of the appliance. Make sure the hot

water line is not twisted and then connect it to the

appliance using an elbow joint. Use Teﬂ on tape or

sealing compound on the connection to avoid leaks.

Do not over tighten the 90° elbow. This can damage

the water inlet and cause a leak.

Connecting the drain line

The drain hose will connect to the drain pump on

the bottom of the appliance. Run the drain line in

the same channel on the bottom of the appliance

as the hot water line. Ensure there is nothing inside

the drain hose and that it does not tear during the

installation process.

There are a number of different ways to connect

the drain hose depending on the conﬁ guration of

the sink. Review the different ways of connecting

the drain system and choose a method that best

suits the application. Local codes may require the

installation of an air gap kit. Check with a qualiﬁ ed

plumber if there is any doubt.

1. Air gap

2. Air gap with garbage disposal

3. No air gap

4. No air gap with garbage disposal

Use a rubber connector to connect drain hoses and

hose clamps on all connection points.

Secure the drain hose to the sink wall using cable

ties or other fastening materials. If not fastened, the

drain hose may bend causing drainage problems.

The drain hose internal diameter is 0.8 inches (21

mm).

The top of the drain hose must be less than 39

inches (100 cm) from the ﬂ oor.

If the drain hose is not looped up the water may

siphon out during a wash cycle.

Any bends in the drain hose must be supported so

that the hose will not kink or bend.

1 2 3 4 5 6 7 8 9 10 ... 43 44

No comments

Danby DDW1804EW Owner's Manual Page 5