(C) Defrost Water Outlet
The interior of the refrigerator is cooled with a cooling
plate mounted in the rear wall. Under the plate there
is a channel and an outlet for defrost water.
Regularly check the defrost water outlet and the drain
channe_ for blockage. They should always be kept
free and clean of food particles. If the drain outlet
does become clogged, use a plastic straw to clean it.
(D) Fruit and Vegetable Crisper
The crisper drawer is on the bottom of the appliance
under the glass shelf. It provides adequate humidity
which has a more
favorable effect on fruits and vegetables (less
dehydration).
(E) Door Liner
The door liner consists of various shelves or holders
used for storing eggs, cheese butter and yogurt as
well as other smaller packages, tubes, cans etc.
The lower shelf is used for storing large bottles.
Illumination in the Interior of
the Refrigerator
The light for illuminating the interior of the refrigerator
is on, when the door is opened, off when the door
is closed.
Operation Control
ELECTRONIC CONTROL OPERATION;
TEMPERATURE INCREASE
_F TEMPERATURE DECREASE
] L_b DtS_'LAY
O'F F_RENHE1T MOOE
0 "_ CE_.S]USMO[31_ ?
0 FAHR_IHErr/CE_U_ SELEffIOR
The electronic LED display on this refrigerator is
programmed to display (independently)the
following temperature(only)information,
INTERNAL CABINET TEMPRATURE:This sett{ng
is represented by a "Steady" state (non-flashing)
LED display and is the normal (LED) default setting
during operation.
SET OPERAT! NG TEMPERATURE: this setting is
represented by a "flashing" LED display and can
only be programmed (SET) by pressing and
releasing either of the A v (temperature)keys
during operation.
NOTE:the set temperature can only be
adjustedlset while the LED is in"flashing" mode.
DEFAULT SETTINGS: When the unit is first
connected to a 120V/60Hz power supply,
(andtor in the event of a power failure)temperature
settings automatically revert to the following
default settings:
The LED default setting for the internal (cabinet)
temperature is the "real time" (ambient) temperature
measured at the time the unit is connected or power
is restored.
The LED default setting for the set operating
temperature is 50" F/lO_ C. (after a power failure
has occurred,the previously set temperature is
automatically erased and will have to be re-set)
The LED default setting for temperature selection
(° FI ° C)is ° F.(FarenheightScale)
SETTING OPERATING TEMPERATURE:To
setlchange the operating temperature;
1.Press and release either of the ,L v (tempe-
rature)keys.
The LED display will temporrarily reverl the
(flashing) set temperature for approximately 5
seconds. (if you fail to set/change the operating
temperature within this 5 second period,the LED
will automatically revert back and display the
internal (cabinet) temperature.
2.Each depression of the ._ key (during flashing
mode) wilt increase the temperature increm
enlally by 1° (temperature ranges between
636" F~46 ° F/2 ° C-8 ° C)
(38 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals