Danby DWC2727BLS User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
8
Installation Instructions - Intergrated Application
Preparing the
Enclosure
FOR YOUR SAFETY:
While performing installations
described in this section,
gloves, safety glasses or
goggles should be worn.
Tools You Will
Need
Carpenters
Square
Measuring Tape
Level
Drill & Hole Saw set
Gloves
Safety Glasses
Flashlight
Electrical Requirements:
The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15 or 20
ampere circuit breaker or time
delay fuse.
It is recommended that you do
not install the wine cooler into a
corner (i.e. directly beside a
wall). This is to allow the door(s)
to have a greater then 90°
opening swing. A limited door
swing will prevent the shelves
from sliding out as intended, and
may lead to damaging the door
gasket(s).
The rough cabinet opening
must be on a level floor area and
at least 24” deep* by 24” wide.
The opening should also have a
height of at least 34-1/2”.
The electrical outlet may be
positioned from within either side
of the adjacent cabinetry, or the
rear of the shaded area (as
shown in Fig C.).
Important: If the electrical outlet
is surface mounted (not flush)
within the enclosure, the depth
requirment for the installation
may be affected.
If the electrical outlet is located
inside the adjacent cabinetry, cut
a 1-1/2” diameter hole to admit
the power cord.
Electrical Access
Fig C
Cabinets
Square
and
Plumb
34-1/2”
From
Underside
of
Countertop
to Floor
24”
6”
2”
24”
Min*
1-1/2” dia. hole
*if electical outlet
is in adjacent
cabinetry
*The listed depth requirment for the installation is assuming that the electrical outlet is located in the
adjacent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Comments to this Manuals

No comments