Danby DPA120B1WB User Manual download pdf (Page 9)

Operating Instructions

OPERATING MODES

FOLLOW ME/TEMP SENSING feature (select models only)

NOTE: This feature can be activated from the remote control ONLY.

The remote control serves as a remote thermostat allowing for

precise temperature control at its location.

To activate the Follow Me/Temp Sensing feature, point the remote

control towards the unit and press the Follow Me/Temp

Sensing button. The remote display is actual temperature at its loca-

tion. The remote control will send this signal to the air conditioner

every 3 minutes interval until the Follow Me/Temp Sensing

button is pressed again. If the unit does not receive the Follow

Me/Temp Sensing signal during any 7 minute interval, the unit will

beep to indicate the Follow Me/Temp Sensing mode has ended.

ELECTRONIC CONTROL

INSTRUCTIONS (con’t)

COOL mode

- Press the "MODE" button until the "COOL" indicator light comes on.

- Press the ADJUST buttons "up + " or "down - " to select your desired

room temperature. The temperature can be set within a range of

17°C-30°C / 62°F-88°F.

- Press the "FAN SPEED" button to choose the fan speed.

HEAT mode (select models only)

- Press the "MODE" button until the "HEAT" indicator light comes on.

- Press the ADJUST buttons "up +" or "down -" to select your desired

room temperature. The temperature can be set within a range of

17°C-30°C / 62°F-88°F.

- Press the "FAN SPEED" button to choose the fan speed. For some

models, the fan speed can not be adjusted under HEAT mode.

AUTO mode

- When you set the air conditioner in AUTO mode, it will automatically

select cooling, heating (select models only) or fan only operation

depending on what temperature you have selected and the room

temperature.

- Under AUTO mode, you can not select the fan speed.

FAN operation

- Press the "MODE" button until the "FAN " indicator light comes on.

- Press the "FAN SPEED" button to choose the fan speed. The

temperature cannot be adjusted.

- Do not use the window hose in this mode.

TIMER operation

- To initiate the “Auto-stop” program: When the unit is on, press the Timer

button, the TIMER OFFindicator light will illuminate.

- To initiate the “Auto-start” program: When the unit is off, press the Timer

button, the TIMER ON indicator light will illuminate.

- Press or hold the “UP +” or “DOWN -” button to change the Auto time by

0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24

hours.The control will count down the time remaining until the unit starts.

- The selected time will register in 5 seconds and the system will

automatically revert back to display the previous temperature setting.

- Turning the unit ON or OFF at any time or adjusting the timer setting

to 0.0 will cancel the Auto Start/Stop timed program.

- When the malfunction (E1,E2,E3 or E4) occurs, the Auto Start/Stop

timed program will also be cancelled.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 34 35

Comments to this Manuals

No comments

Danby DPA120B1WB User Manual Page 9

Comments to this Manuals

Related products and manuals for Mobile air conditioners Danby DPA120B1WB