Danby DAC150ECB1GDB User Manual download pdf (Page 19)

INSTALLATION INSTRUCTIONS

Install Top Angle and Side Bracket:

1. Attach foam gasket to top angle above holes as shown in Fig. F.

2. Install top angle and side retainers to cabinet as shown in Fig. F.

5/16in. (8mm)

long hex-head

Fig. F

Assemble Window Filler Panels (see Fig. G):

1. Place cabinet on ﬂ oor, a bench, or table.

2. Slide the window ﬁ ller panel frame into the top (L

shaped) and bottom (U shaped) channels. The shut-

ters are identiﬁ ed (on the frame) as left and right.

3. Insert washer head locking screws (2) into holes in

top leg of ﬁ ller panel frame. Do not totally tighten. Al-

low left to slide freely. Screws will be tightened later.

Plastic

Frame

“U”Shaped Channel

Window Filler Panel

“L” Shaped Mounting

Bracket

Install Top Angle and Side Bracket:

1. Open window and mark center of window sill.

2. Place cabinet in window with lower “U” channel of

cabinet ﬁ rmly seated over window sill. Bring window

down temporarily behind top “L” bracket to hold

cabinet in place.

3. Shift cabinet left or right as needed to line up center

of cabinet on centre line marked on window sill.

4. Fasten cabinet to window sill with 2 screws (you

may want to pre-drill holes).

5. Add bottom rail seal over screws to window sill. See

Fig. H.

Fig. H

Bottom

Rail Seal

3/4in.(19mm) Long

Hex-head Screw

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 45 46

No comments

Danby DAC150ECB1GDB User Manual Page 19