Danby DAC150ECB1GDB User Manual download pdf (Page 21)

INSTALLATION INSTRUCTIONS

Install Chassis into Cabinet and Install:

1. Lift chassis and carefully slide into cabinet, leaving 6 inches protruding.

2. DO NOT push on controls or coils.

3. Be sure the chassis is ﬁ rmly seated towards rear of cabinet.

4. Installation of front is the reverse of removal, outlined in section 1 (“Remove Chassis”)

Safety Lock

1/2” screw

Window

Sash Seal

Fig.M

locking screw &

flat washer.

13/16in.(20mm) Screw & Frame Lock (2)

Fig.L

7/16in.(12mm)

CARE AND MAINTENANCE

CLEANING THE AIR FILTER

CAUTION

Before cleaning or servicing this unit, disconnect from any electrical supply outlets to prevent

possible shock or ﬁ re hazard.

• DO NOT use gasoline, benzene, thinner, or any other chemicals to clean this unit, as these substances may cause

damage to the ﬁ nish and deformation of plastic parts.

• Never use harsh cleaners, wax or polish on the cabinet front.

The air ﬁ lter should be checked at least once a month to see if cleaning is

necessary. Trapped particles in the ﬁ lter can build up and cause accumulation

of frost on the cooling coils.

• Push the vent handle to the vent closed position.

• Open the front panel.

• Grasp the ﬁ lter, pull up and out.

• Wash the ﬁ lter using liquid dishwashing detergent and warm water. Rinse

ﬁ lter thoroughly.

• Gently shake excess water from the ﬁ lter. Be sure the ﬁ lter is thoroughly

dry before replacing.

• You may vacuum the ﬁ lter to clean.

Note: Never use hot water over 40°C (104°F) to clean the air ﬁ lter.

CAUTION

Never operate this unit without the air ﬁ lter in place, as this may

result in damage to the unit.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 45 46

No comments

Danby DAC150ECB1GDB User Manual Page 21