Danby DAC150ECB1GDB User Manual download pdf (Page 17)

1. This room air conditioner is designed to ﬁ t easily into a single or double hung window. However, since window designs

vary, it may be necessary to make some modiﬁ cations for safe, proper installation.

2. Make sure window and frame are structurally sound and free from dry and rotted wood.

3. For maximum efﬁ ciency, install the air conditioner on a side of the house or building which favours more shade than

sunlight. If the unit is in direct sunlight, it is advisable to provide an awning over the unit.

4. Provide sufﬁ cient clearance around the cabinet to allow for ample air circulation through the unit (See Fig. 2). The

rear of the unit should be outdoors. It should not be in a garage, or inside a building. Keep unit as far away as possi-

ble from obstacles/obstructions and at least 30 in. (76 cm) above the ﬂ oor or ground. Curtains and other objects within

the room should be prevented from blocking the air ﬂ ow.

5. Be certain that the proper electrical outlet is within reach of the installation. Use only a single outlet circuit rated at 15

amps. All wiring should be in accordance with local and national electrical codes.

6. DO NOT install unit where leakage of combustible gas is suspected. Your air conditioner may fail to operate in air

containing oils (including machine oils), sulﬁ de gas, near hot springs, etc.

NOTE: Your unit is designed to evaporate condensation under normal conditions. However, under extreme humidity con-

ditions, excess condensation may cause basepan to overﬂ ow to the outside. The unit should be installed where conden-

sation run-off cannot drip on pedestrians or neighbouring properties.

NOTE: It is normal for your unit to drip a small amount of water, especially on excessively humid days.

INSTALLATION INSTRUCTIONS

LOCATION

Awning

Fence,

wall, or

other

obstacle

Ground

Side

Obstruction

20 in.

(50.8 cm)

Min

30 in. (76.2 cm)

Min

12 in. (30.5 cm) Min

20 in.

(50.8 cm)

Fig. 2

NOTE: Save the shipping carton and packing materials for future storage or transportation. From the carton, remove the

plastic bag containing the installation hardware kit necessary for the installation of your air conditioner. Please check the

contents of the hardware kit against the corresponding model check list, prior to installation.

NOTE: Your Room Air Condtioner is designed for easy installation in a single or double-hung window. This unit is NOT

designed for vertical (slider type) windows and/or through-the-wall applications.

CAUTION

Because the compressor is located on the controls side

of the unit (left side), this side will be heavier and more

awkward to manipulate. Inadequate support on control

side of the unit and property. Therefore, it is recom-

mended that you have someone assist you during the

installation of this unit.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Comments to this Manuals

No comments

Danby DAC150ECB1GDB User Manual Page 17

Comments to this Manuals

Related products and manuals for Conditioners Danby DAC150ECB1GDB