Danby DR202BGLP Owner's Manual download pdf (Page 13)

INSTALLATION INSTRUCTIONS

To reduce the risk of the appliance tipping, the anti-

tip bracket must be installed before operation.

Note: The installation of the anti-tip bracket must

meet all local codes for securing the appliance.

The anti-tip bracket must be secured to either the

rear wall or the ﬂ oor and must be positioned in such

a way that it will overhang the anti-tip arm on the

rear of the appliance.

Rear wall installation

Use the two screws provided to secure the bracket

to the rear wall. The screws must enter a wood sill

plate. If the wall contains any metal studs or similar

materials, or if the back of the appliance cannot

reach the rear wall, the ﬂ oor installation should be

used.

Floor installation

Wood ﬂ oor: Use the two screws provided to secure

the bracket to the ﬂ oor.

Concrete ﬂ oor:

1. Mark the location where the screws need to be

installed.

2. Use a power drill and a concrete bit to drill a

5/32” pilot hole 2” deep into the concrete at the

center of each of the marked locations.

3. Use the two screws provided to secure the

bracket to the ﬂ oor.

Double check the installation

After installing the bracket, slide the appliance into

its ﬁ nal location. Look underneath the appliance

and ensure that the anti-tip arm attached to the side

panel of the appliance is engaging the bracket.

ANTI-TIP BRACKET INSTALLATION

1. Anti-tip arm on the back of the appliance

2. Anti-tip bracket

3. Screw must enter wood or concrete

4. Wall sill plate

5. Screw must enter wood

ELECTRICAL CONNECTIONS

Electrical requirements:

120 volt, 60 hertz, properly grounded dedicated

circuit protected by a 15 amp or 20 amp circuit

breaker or time delay fuse.

NOTE: Use of automatic, wireless, or wired external

switches that shut off power to the appliance are not

recommended for this product.

WARNING SHOCK HAZARD: This appliance must

be properly grounded. Failure to do so can result in

electric shock.

The power cord of this appliance is equipped with

a three prong (grounding) plug which mates with

a standard three-prong grounding wall receptacle

to minimize the possibility of electric shock hazard

from this appliance.

The customer should have the wall receptacle and

circuit checked by a qualiﬁ ed electrician to make

sure the receptacle is properly grounded.

Where a standard two-prong wall receptacle is

encountered, it is the personal responsibility and

obligation of the customer to have it replaced with a

properly grounded three-prong wall receptacle.

DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR

REMOVE THE THIRD (GROUND) PRONG FROM

THE POWER CORD.

DO NOT USE AN ADAPTER.

DO NOT USE AN EXTENSION CORD.

A word about GFCIs - GFCIs are not required or

recommended for gas range receptacles.

Ground Fault Circuit Interrupters (GFCIs) are

devices that sense leakage of current in a circuit and

automatically switch off power when a threshold

leakage level is detected. These devices must be

manually reset by the consumer. The National

Electrical Code requires the use of GFCIs in kitchen

receptacles installed to serve countertop surfaces.

Performance of the range will not be affected if

operated on a GFCI-protected circuit but occasional

nuisance tripping of the GFCI breaker is possible.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 53 54

Comments to this Manuals

No comments

Danby DR202BGLP Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Unknown Danby DR202BGLP