Danby DR202BGLP Owner's Manual download pdf (Page 12)

INSTALLATION INSTRUCTIONS

4 WIRE POWER CORD INSTALLATION

The neutral wire of the supply circuit must be

connected to the neutral terminal located in the

lower center of the terminal block. The power

leads must be connected to the lower left and the

lower right terminals of the terminal block. The 4th

grounding lead must be connected to the frame of

the range with the ground plate and the ground

screw.

1. Remove the three lower terminal screws from the

terminal block.

2. Remove the ground screw and ground plate and

retain them.

3. Cut and discard the ground strap. Do not

discard any screws.

4. Insert the one ground screw into the power cord

ground wire terminal ring, through the ground

plate and into the frame of the range.

5. Insert the three terminal screws that were

removed earlier through each power cord

terminal right and into the lower terminals of the

terminal block.

6. Be certain that the center wire is connected to

the center lower position of the terminal block.

7. Tighten the screws securely into the terminal

block.

After

1. Terminal block

2. Neutral terminal

3. Ground plate (grounding to range)

4. Ground screw

Before

1. Terminal block

2. Ground strap

3. Neutral terminal

4. Cut and discard the ground strap

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

No comments

Danby DR202BGLP Owner's Manual Page 12