Danby DWC516BLS User Manual download pdf (Page 10)

Installation Instructions - Door Swing Reversal

FIG 1A

1. Unplug the unit from electrical oulet (if connect-

ed) and lay it on it’s back.

2. Open the door until the screws securing the

lower door support bracket are exposed on the

bottom of the door (Fig 1B).

3. Remove the screw that is closest to the hinge assem-

bly and gently close the door to remove the remaining

screw from the support bracket.

4. Swing the door slightly towards the left side in

order to remove the support bracket from the door

and the lower hinge assembly.

5. Pull the door downward to remove it from the

cabinet of the wine cooler.

6. Remove the cap from the top left side of the

door (Fig 1D) and reinstall it on the top right side.

7. Remove the three (3) screws supporting the

top hinge (Fig 1A) and the three (3) screws sup-

porting the bottom

hinge.

8. Remove the plastic caps from the left side of

the frame (Fig 1C) and reinstall them on the right

side of the frame (the previous hinge location).

9. Install the new left hand hinge assembly (sup-

plied with unit) on the left side of the frame.

10. Insert the lower door support into the left side

bottom hinge.

11. Carefully reposition the door firstly into the left

side upper hinge assembly then onto the lower

door support bracket.

12. While the door remains closed install the first

screw into the lower support bracket.

13. Open the door and install the screw that is

closest to the hinge assembly.

14. Close the door and return the unit into it’s

upright position (wait 60 mins before reconnect-

ing power to the wine cooler), verify the door

alignment and proper seal against the cabinet.

FIG 1C

Plastic Caps (3)

Upper Hinge

FIG 1D

Door Plug

Lower Hinge Assembly

and Door Support Bracket

FIG 1B

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 37 38

Comments to this Manuals

No comments

Danby DWC516BLS User Manual Page 10

Comments to this Manuals

Related products and manuals for Wine coolers Danby DWC516BLS