Danby SSBC056D2BS Use and Care Guide download pdf (Page 6)

GROUNDING INSTRUCTIONS

This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an

outlet that is properly installed and grounded.

This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock

by providing an escape wire for the electric current.

WARNING - Improper use of the grounding plug can result in a risk of electric shock. Consult a qualiﬁ ed electrician or

service agent if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is

properly grounded.

If the outlet is a standard 2-prong wall outlet, it is your personal responsibility and obligation to have it replaced with a

properly grounded 3-prong wall outlet.

For best operation, plug this appliance into its own electrical outlet to prevent ﬂ ickering of lights, blowing of fuse or trip-

ping of circuit breaker

DO NOT USE AN EXTENSION CORD

Use an exclusive 115V wall outlet. Do not connect your appliance to extension cords or together with another appliance

in the same wall outlet. Do not splice the cord. Do not under any circumstances cut or remove the third (ground) prong

from the power cord. Do not use and adapter plug with this appliance.

SAVE THESE INSTRUCTIONS!

Important Safety Information

READ AND FOLLOW ALL SAFETY INSTRUCTIONS

Installation Instructions

FOR YOUR SAFETY

• While performing installations described in this section, gloves and goggles or safety glasses should be worn. Two

people should be used when moving the cooler.

• Remove interior and exterior packaging prior to installation.

• Before connecting the appliance to a power source, let it stand upright for approximately 6 hours; this will reduce the

possibility of a malfunction in the cooling system from handling during transportation.

• Place your cooler on a ﬂ oor that is strong enough to support it when it is fully loaded. To level your cooler, adjust the

front leveling leg at the bottom of the unit.

• Locate the cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight and heat

sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the unit to perform

improperly.

• Avoid locating the unit in moist areas.

• Plug the cooler into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or

remove the third (ground) prong from the power cord. Any questions concerning power and/or grounding should be

directed toward a certiﬁ ed electrician or an authorized service centre.

• Do not cover shelves with aluminum foil or any other material which may prevent air circulation.

• In order for the cabinet to remain efﬁ cient do not over load it.

• Do not open the door unless necessary.

• Should the cooler be stored without use for long periods, it is suggested, after careful cleaning, to leave the door

ajar. This will allow air to circulate inside the cabinet in order to avoid possible formations of condensation, mold and

odors.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Danby SSBC056D2BS Use and Care Guide Page 6