Danby Millennium DAR254W Owner's Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 14
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
ELECTRICAL RATING
The "serial rating plate" indicates the voltage
and frequency the freezer is designed for.
Due to possible variations in line voltage
(caused by overloading of circuits), it is
advisable to install a separate fuse circuit
from the meter panel This will help to
eliminate current fluctuation which might
cause motor trouble.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the
event of an electrical short clrcutt, grounding
reduces the risk of electrical shock by
providing an escape wire for lhe electrical
current. This appliance is equipped with a
cord having a grounding wtre with a grounding
plug_ The plug must be plugged Into an oullet
that is properly installed and grounded,
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect
your freezer to exlenslon cords or together
with any other appliance tn the same wall
outlet. Do not splice the cord.
IMPORTANT WARNING
An empty freezer is a very dangerous
attraction to children. Remove either the
gasket or lid from unused appliances, or take
some other action that will guarantee
it harmless.
DANGER:Rtskof chltdentrapmentBeforeyouthrowaway
your old refrigemloror freezer:
*Takeoffthedoors
* Leavelhe shelvesinplacesothatchlld_emm_3'
not easilyclimbInside
DON'TWAIT DO IT NOWI
Location
Points to considerwhen locating your freezer:
I4
2o
Locate the freezer in such a manner that
extension cords are not necessary.
Due to lid and hinge arrangement, It is
impossible to install freezer directly against
the walloThe spacing on the back is essential
for maintaining proper air circu]ation around
the freezer.
Select a tocatlon with reasonable year round
temperatures. Do not operate freezer when
surroundlng air temperature is below 0_Co
However, it will not harm freezer to stand in
any temperature below 0=C provided the
temperature control is set to avoid running the
unit. in order to keep operating cost down, do
not place freezer near a stove, furnace, heat
regisler or tn direct sunlight If the place
selected for your freezer is damp or moist, as
in basements, place freezer on wooden
blocks,. (2 or 3 2 x 4's under enlire length will
assure adequate support)..
Starting the Freezer
The freezer is ready to operate as received when
connected to the power supply,. After slatting,
close fid and allow freezer to opefatOoThe unit
will run from 1 to 2 hours {possibly longer,
depending on conditions) before operaling
Iemperature is reached. It will then start and
stop (cycle) at fairly regular intervals. It is
recommended that food should not be pieced in
freezer until you are satisfied that it is operating
regularly and no final adjustments are necessary.
Once your freezer is starting and stopping
(cycles) regularly, il is ready to freeze and store
foods, The proper food storage temperature is
-18_C (0°F). Do not operate freezer at
temperatures below -19°C (-3°F), since it does
not improve food preservation and only results in
longer unit (cycle) running time. I! is not
advisable to freeze more than 25 kg. (50 Ibs..)of
food in a 450 Jitre(16 cu. fL) freezer in any 24
hour period.. In a smaller or larger size, thts is
proportionately smaller or larger. It will take 15
or more hourS of unit running time to freeze this
amount of food° When adding fresh, unfrozen
food packages, store them against the walls.
The sensing bulb of the thermostat ts fastened
to the liner wall on the "insulation side" of
the freezer..
In view of the value of the contents of your
freezer, it Is advisable to inspect contenls and
operation regularly.
Page view 2
1 2 3 4 5 6 7 8 ... 13 14

Comments to this Manuals

No comments