Danby DKC054A1BSL2DB Owner's Manual download pdf (Page 14)

Plastic Faucet Lever

Attach the black plastic lever (pull handle) to the top of the faucet by

tightening it by hand going clockwise until the end, holding in the silver nut

underneath so it does not turn. If there is still a small drip from the faucet,

you may have overtightend the silver nut and may need to unscrew silver

snug going counter-clockwise (as shown one turn).

DISPENSING OF BEER

• Keep beer keg refrigerated at all times.

• Never allow beer lines to dry out.

• Use clean glassware before pouring.

• Hold glass at a 45° angle, when it is 2/3 full, start to straighten glass as the glass ﬁ lls.

• Always make sure the faucet handle is pushed all the way back.

This keg cooler has been designed to chill and dispense beer from two of the following size kegs

simultaneously:

Note: The refrigerator compartment cannot accommodate the “Coors” style beveled barrel keg.

Note: Our keg cooler accepts domestic kegs up to 16-1/8” in diameter and up to 23-3/8” in height.

Check with your distributor to make sure keg is correct size.

Note: It is important to allow the keg to sit upright and undisturbed, for 2 hours before tapping.

Spanner Faucet Wrench

Spanner faucet wrench (provided) is for either removing or tightening the

faucet connection.

Note: To prevent leakage, use the provided wrench to further tighten the

faucet connection.

Installation Instructions

1/6 barrel 20 Liters 5.2 gals. 661 oz. 55 x 12-oz. Glasses

1/8 barrel 15 Liters 4.0 gals. 496 oz. 41 x 12-oz. Glasses

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 51 52

No comments

Danby DKC054A1BSL2DB Owner's Manual Page 14