Danby DKC054A1BSL2DB Owner's Manual download pdf (Page 13)

Installation of the Keg Coupler

Insert the keg coupler into the locking neck of the beer keg and turn it clockwise to lock into position,

making sure the keg coupler handle is in the closed position, with the handle up.

How to Tap a Keg of Beer

• Make sure the CO

is turned off and the valve on the regulator is in the closed position.

• Pull out and release the pressure release valve on the coupler to purge any air pressure.

• Make sure the beer tower faucet handle is in the closed position.

• Pull coupler handle out and downward until it locks into its open position. The teeth on the

underside of the coupler will bite into the locking neck of the beer keg.

Note: If a keg is very tall, it may be necessary to connect the coupler to the keg before inserting the

keg into the keg cooler.

Opening the CO

Cylinder Main Valve

• Make sure the secondary shut-off valve (shown below in “open” position) is closed. To open the

main CO

cylinder valve, slowly turn the main valve counter-clockwise until fully open.

• Notice the needle on the regulator gauge start to climb.

Adjusting the CO

Regulator

The gauge monitors low internal keg pressure and should

be adjusted to read between 8-12 PSI. The pressure can be

adjusted as needed. If the beer is very foamy, try turning the

PSI down. If the ﬂ ow of beer is very weak, try turning the PSI

up.

Note: After making any adjustment to the PSI, wait 5 - 10

minutes before attempting to pour another beer to allow the

pressure to equalize.

• Release adjustment lock nut marked 2.

• Using a ﬂ at screwdriver, turn regulator screw marked 3.

- To increase pressure, turn screw clockwise.

- To decrease pressure, turn screw counter-clockwise.

• Retighten lock nut marked 2.

• Open secondary shut off valve to let CO

ﬂ ow into the

keg.

• Allow several minutes for the keg to properly pressurize.

Regulator gauge may drop while this happens.

Note: Listen for hissing along all connections to identify if

there are any leaks.

Installation Instructions

Coupler closed position Coupler open position

Coupler pressure

release valve

Secondary shut off valve

Main shut

off valve

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Comments to this Manuals

No comments

Danby DKC054A1BSL2DB Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Unknown Danby DKC054A1BSL2DB