Danby DIM32D1BSSPR Owner's Manual download pdf (Page 9)

OPERATING INSTRUCTIONS

CHANGING THE SIZE OF ICE

NOTE: Ice cube sizes differ by density and not volume. A large cube is the same size as a small cube but contains

more frozen water.

1. Ensure the water supply is connected before changing ice size. The ice maker is automatically set to make

medium ice. If you need to change the ice size, you can press the corresponding buttons (see previous page) and

the chosen ice size will be indicated by the corresponding indicator light.

2. If you want to stop making ice but keep the unit on standby, press the power button for about 3 seconds. All ice

indicator lights will turn off and the power indicator light will continue ﬂ ashing. You are now in standby mode. Do

not leave the unit in standby mode in excess of 6 hours. If you want to start making ice again, press the power

button one more time.

ICE BUCKET

Your ice bucket is designed to be easily removed. To remove it, tilt up the front part of the box then simply pull it out

(see Fig. F)

CONTINUOUS WATER CIRCULATION

This unit operates using a continuous closed cycle of

water, with little or no waste. When the unit is on and the water container is low, new water is allowed in from the water

source. The water container ﬁ lls up until the ﬂ oat on the water tank is triggered. The recirculation pump cycles water

over the evaporator tray continuously until ice is produced. This process is continuous as long as the unit is left on.

Any water that enters the drain at the bottom of the ice maker cavity is not recycled. It goes into a separate receptacle

with a separate drain system that drains out of the back of the unit. This ensures that you’re always using clean water.

Note: If the unit is turned off for 24 hours or longer, drain the water from the recirculation system. (see below)

Note: If you are using the continuous drain option (see separate installation instructions) the unit may be turned off

during the draining process. If you are using the drain pump option (see separate installation instructions), you must

keep the unit turned on.

To drain the water from the system: First turn off the water supply. Remove the ice bucket, and pull the rubber

drain tube out from its clips at the front of the internal water reservoir. Slowly lower the rubber drain tube towards the

drain port at the back right side of the ice maker cavity. The water will evacuate. When all the water has been drained,

replace the tube. Note: If using the continuous drain option (see separate installation instructions) and the unit

had been turned off, it may now be turned on again.

This machine is intended to produce ice only. It is not intended for the

long-term storage of ice. Move any excess ice into a freezer for long-term

storage (>6 hours) if you desire to keep it.

IMPORTANT

Fig. F

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

No comments

Danby DIM32D1BSSPR Owner's Manual Page 9