Danby DAC15009EE Operations Instructions download pdf (Page 11)

INSTALLATION (cont’d)

Install Support Bracket

1) Hold each support bracket flush against outside of sill, and tighten to bottom of cabinet as shown in Fig. I.

Mark brackets at top level of sill, and remove.

2) Assemble sill anchor bracket to outside support legs at the market positon, as seen in Fig. J. Hand tighten,

but allow for any changes later.

3) Install support brackets (with sill anchor brackets attached) to correct hole in bottom of cabinet as shown in

Fig. K.

4) Tighten all 6 bolts securely.

Fig. I

Anchor

Fig. J

Fig. K

Extend Window Filler Panels

1) Extend panels to fill window opening completely. Secure the shutter

clamp on each side of the (upper)shutter and secure to window sill using

one 7/16in.(11.1mm) locking screw & flat washer on each side. (Fig.L)

2) Attach frame lock to window sill using one 1-3/16in. (20mm) screw on

each side as shown in Fig. L

Install Window Lock and Sash Seal

1) Trim sash seal to fit window width. Insert into space between upper

and lower sashes (Fig. M).

2) Attach right angle safety lock as shown in Fig. M.

Fig. L

Window Sash Seal

/4” long Hex-head

screw

Fig. M

Install Chassis into Cabinet and Install

Front to Unit

1) Lift chassis and carefully slide into cabinet, leaving

6 inches protruding.

2) DO NOT push on controls or coils.

3) Be sure the chassis is firmly seated towards rear of

cabinet.

4) Installation of front is the reverse of removal,

outlined in section 1 (“Remove Chassis”).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 25 26

No comments

Danby DAC15009EE Operations Instructions Page 11