Danby DAC15009EE Operations Instructions download pdf (Page 10)

INSTALLATION (cont’d)

Remove Chassis (cont’d)

5) Gently lift front off unit and place to one side (See. Fig. D)

6) Remove shipping screws from top of unit and also on the side by the base if installed.

7) Hold the cabinet while pulling on the base handle, and carefully remove the chassis from the cabinet.

8) Add two foam inserts to holes in top of cabinet where shipping screws were removed from (See Fig. E).

9) Your unit may come with internal packaging. This packaging must be removed prior to installing the air

conditioner back into the cabinet.

Fig. E

Foam Inserts

Install Top Angle and Side Bracket

1) Attach foam gasket to top angle above holes as shown in Fig. F.

2) Install top angle and side retainers to cabinet as show in Fig. F.

Assemble Window Filler Panels

1) Place cabinet on floor, a bench, or a table.

2) Slide the window filler panel frame into the top (L shaped) and bottom (U

shaped) channels. The shutters are identified (on the frame) as left and right.

3) Insert washer head locking screws (2) into holes in top leg of filler panel

frame. Do not totally tighten. Allow leg to slide freely. Screws will be tightened

later.

Fig. F

“L” Shaped

mounting

bracket

“U” Shaped

Channel

Install Top Angle and Side Bracket

1) Open window and mark center of window sill.

2) Place cabinet in window with lower “U” channel of cabinet

firmly seated over window sill. Bring window down temporarily

behind top “L” bracket to hold cabinet in place.

3) Shift cabinet left or right as needed to line up center of cabinet

on center line marked on window sill.

4) Fasten cabinet to window sill with 2 screws (you may want to

pre-drill holes).

5) Add bottom rail seal over screws to window sill. See Fig. H

Fig. H

Fig. D

Fig. G

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

No comments

Danby DAC15009EE Operations Instructions Page 10