Danby DAC10000 Operations Instructions download pdf (Page 11)

Operating Instructions

DIGITAL CONTROLS

REMOTE CONTROL

• To ensure proper operation, aim the remote control at the signal receiver

on the air conditioner.

• The remote control signal has a range of up to 20 feet.

• Make sure nothing is between the air conditioner and the remote control

that could block the signal.

• Make sure batteries are fresh and installed correctly as indicated on the

remote control.

Use the Cool mode at Low, Med, High or Auto Fan Speed for cooling.

Use the Temperature Increase / Decrease pads to set the desired

temperature between 64°F and 86°F in 1°F increments.

An electronic thermostat is used to maintain the room temperature. The

compressor will cycle on and off to keep the room at the set level of com-

fort. Set the thermostat at a lower number and the indoor air will become

cooler. Set the thermostat at a higher number and the indoor air will

become warmer.

NOTE: If the air conditioner is off and is then turned on while set to a Cool

setting or if turned from a fan setting to a Cool setting, it may take approxi-

mately 3 minutes for the compressor to start and cooling to begin.

Cooling Descriptions

For Normal Cooling — Select the Cool mode and High or Med fan with

a middle set temperature. For Maximum Cooling — Select the Cool

mode and High fan with a lower set temperature. For Quieter &

Nighttime Cooling — Select the Cool mode and Low fan with a middle

set temperature.

COOL MODE

ENERGY SAVER MODE

The fan will cycle on and off with the compressor. This results in wider

variations of room temperature and humidity. Normally used when the

room is unoccupied.

NOTE: The fan may continue to run for a short time after the compressor

cycles off.

FAN ONLY MODE

Use the Fan Only Mode at Low, Med or High fan speed to provide air cir-

culation and filtering without cooling. Since fan only settings do not

provide cooling, a Set temperature cannot be entered. The room

temperature will appear in the display.

NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.

AUTO FAN SPEED

Set to Auto fan speed for the fan speed to automatically set to the speed

needed to provide optimum comfort settings with the set temperature.

If the room needs more cooling, the fan speed will automatically increase.

If the room needs less cooling, the fan speed will automatically decrease.

NOTE: Auto Fan Speed cannot be used when in the Fan Only Mode.

POWER OUTAGE

RECOVERY FEATURE

In the case of a power outage or interruption, the unit will automatically re-

start in the settings last used after the power is restored. If the Delay

1–24hr feature was set, it will countdown according to the memorized

time. You may need to set a new time if desired.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 38 39

Comments to this Manuals

No comments

Danby DAC10000 Operations Instructions Page 11

Comments to this Manuals

Related products and manuals for Mobile air conditioners Danby DAC10000