Danby DAC10000 Operations Instructions download pdf (Page 6)

Installation Instructions

WARNING

When handling unit, be careful to

avoid cuts from sharp metal edges

and aluminum fins on front and rear

coils.

HOW TO

INSTALL

NOTE: Top Rail and Sliding Panels at each side are offset to provide the

proper pitch to the rear of (5/16"). This is necessary for proper condensed

water utilization and drainage. If you are not using the Side Panels for

any reason, this pitch to the rear must be maintained to allow water build

up in humid conditions to drain outside.

A. Place unit on floor, a bench or a table. There is a Left and Right

Window Filler Panel - be sure to use the proper panel for each

side.When installed the flange for securing the panel in place to the

window sill will be facing into the room.

Hold the accordion panel and gently pull out past the open end of the

frame. See Figure 2.

TOOLS NEEDED

• Phillips Screw Driver

• Drill (If pilot holes are needed)

Fig. 2

Fig. 3A

B. Slide the free end (“I”section) of the panel into the cabinet as shown in

Figures 3A, 3B & 4. Slide the panel down. Be sure to leave enough

space to slip the top and bottom of the frame into the rails on the

cabinet.

Fig. 3B

Fig. 4

* See www.danby.com for

video instructions.

1 2 3 4 5 6 7 8 9 10 11 ... 38 39

No comments

Danby DAC10000 Operations Instructions Page 6