Danby DOM161KBLSDD User Manual download pdf (Page 46)

INSTALLATION INSTRUCTIONS

OUTSIDE BACK EXHAUST

(Horizontal Duct)

INSTALLATION OVERVIEW

B1. Prepare Rear Wall

B2. Remove Exhaust Adaptor

B3. Attach Mounting Plate to Wall

B4. Prepare Top Cabinet

B5. Adjust Blower

B6. Mount the Microwave Oven

IMPORTANT NOTES:

• Make sure the screws for the

blower motor and blower plate

are securely tightened when they

are reinstalled. This will help to

prevent excessive vibration.

• Make sure the motor wiring has

been properly routed and

secured, and that the wires are

not pinched.

PREPARING THE REAR WALL

FOR OUTSIDE BACK EXHAUST

You need to cut an opening in the rear wall for

outside exhaust.

• Read the instructions on the REAR WALL TEMPLATE.

• Tape it to the rear wall, lining up with the holes

previously drilled for holes A and B in the wall plate.

• Cut the opening, following the instructions of the

REAR WALL TEMPLATE.

REMOVE EXHAUST ADAPTOR

This microwave oven is shipped assembled for top

exhaust. You will need the exhaust adaptor for

installation in the rear wall opening. To remove the

exhaust adaptor from the microwave oven:

Remove tape securing damper.

Raise damper flap.

Blower Plate

Back of

Micowave

Slip the damper

out of the track

on the blower

frame by pressing

and twisting

both ends.

Remove and save the screw that holds the blower

plate to the microwave. Lift off the blower plate.

Back of

Microwave

Blower Plate

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 76 77

Comments to this Manuals

No comments

Danby DOM161KBLSDD User Manual Page 46

Comments to this Manuals

Related products and manuals for Microwaves Danby DOM161KBLSDD