Danby DOM161KBLSDD User Manual download pdf (Page 43)

INSTALLATION INSTRUCTIONS

OUTSIDE TOP EXHAUST

(Vertical Duct)

INSTALLATION OVERVIEW

A1. Attach Mounting Plate to Wall

A2. Prepare Top Cabinet

A3. Check Damper Operation

A4. Mount Microwave Oven

A5. Adjust Exhaust Adaptor

A6. Connect Ductwork

ATTACH THE MOUNTING

PLATE TO THE WALL

Attach the plate to the wall using toggle bolts.

At least one wood screw must be used to attach

the plate to a wall stud.

1. Remove the toggle wings from the bolts.

2. Insert the bolts into the mounting plate through the

holes designated to go into drywall and reattach the

toggle wings to 3/4’’ onto each bolt.

TO USE TOGGLE BOLTS

3. Place the mounting plate against the wall and insert the

toggle wings into the holes in the wall to mount the

plate.

NOTE: Before tightening toggle bolts and wood screw,

make sure the tabs on the mounting plate touch the bottom

of the cabinet when pushed flush against the wall and that

the plate is properly centered under the cabinet.

CAUTION: Be careful to avoid pinching fingers between

the back of the mounting plate and the wall.

4. Tighten all bolts. Pull the plate away from the wall to

help tighten the bolts.

Wall

Mounting

Plate

Spacing for Toggles

More Than Wall

Thickness

Bolt End

Toggle

Bolt

Toggle Wings

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 76 77

No comments

Danby DOM161KBLSDD User Manual Page 43