Danby DOM161KBLSDD User Manual download pdf (Page 41)

INSTALLATION INSTRUCTIONS

ALIGNING THE WALL PLATE

CAUTION: Wear gloves

to avoid cutting fingers on

sharp edges.

Draw a Vertical

Line on Wall

from Center of

Top Cabinet

Area E

Hole A

Hole B

Hole D

Hole C

Centerline

Notches

CAUTION: Wear gloves

to avoid cutting fingers on

sharp edges.

1. Draw a vertical line on the wall at the center of the 30’’

wide space.

2. Use the mounting plate as the template for the rear

wall. Place the mounting plate on the wall, making

sure that the tabs are touching the bottom of the

cabinet or the level line drawn in Step C for cabinets

with front overhang. Line up the notch and centerline

on the bottom of the mounting plate to the centerline

on the wall.

3. While holding the mounting plate with one hand, draw

circles on the wall at holes A, B, C and D (see

illustration above/actual plate marked with arrows). Four

holes must be used for mounting.

NOTE: Holes C and D are inside area E. If neither C nor

D is in a stud, find a stud somewhere in area E and draw

a fifth circle to line up with the stud. It is important to use

at least one wood screw mounted firmly in a stud to sup-

port the weight of the microwave. Set the mounting plate

aside.

4. Drill holes on the circles. If there is a stud, drill a 3/16’’

hole for wood screws. For holes that don’t line up with

a stud, drill a 5/8’’ hole for toggle bolts.

NOTE: DO NOT MOUNT THE PLATE AT THIS TIME.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 76 77

No comments

Danby DOM161KBLSDD User Manual Page 41