Danby dim1524w Owner's Manual download pdf (Page 18)

Operating Instructions

To immediately begin the ice

making process;

• Remove ice bucket and add

water to Fill line.

(approx. 3.5 L)

• Reinsert the ice bucket and

press the Power button.

• Select the desired ice cube

size

(See “Ice Size” below).

• The ice maker will automati-

cally begin approximately 15

seconds after the last button

is pressed.

Please note: The length of

the ice making process is

directly proportionate to the

current ice size setting and

batch completion time range

between 9 minutes and 15

minutes per cycle, depending

upon your ice size selection.

For optimal results, please

keep the ice maker door

closed during the ice making

process.

Ice Making

1 Add water to ‘fill line’.

2 Press the power button.

3 Change the ice size if you

don’t want medium cubes.

Delayed Start

• Remove ice bucket and add

water to Fill line.(approx. 3.5 L)

• With the power off. Press

the Increase/Decrease but-

tons once simultaneously to

enter the timer set mode.

• Each subsequent press of

the increase button will

increase the timer in 30

minute increments up to 12

hours. Alternatively to

subtract time from the timer,

press the decrease button to

decrease the timer by 30

minute increments.

• Reinsert the ice bucket and

select the ice size you

require.

• The ice maker timer will

automatically start 10 sec-

onds after the last button is

pressed.

To cancel the timer at any

time and begin the ice making

process immediately, simply

press the power button.

1 Add water to ‘fill line’.

2 Ensure the power is off.

3 Press the increase &

decrease arrows

simultaneously

4 Select timer length.

5 Select required ice size.

Ice Size

Selection

The ice size selection button

allows you to choose from

small, medium or large ice

cubes.

By default your ice maker is

configured to produce medi-

um size ice cubes. However

if you would like a different

size of cube, you need only

depress the ice size selection

button to cycle between the

three (3) available sizes

(small, medium and large.)

Ice size change is possible

during the running ice making

cycle, however it is recom-

mended to wait until the cur-

rent cycle is complete before

defining a new ice size.

NOTE: Unless there is a

power failure or power inter-

ruption to the unit. The ice

size selection you have made

will be retained as the default

ice size.

1 Press Power or

enter Delayed Start

mode (see below).

2 Depress the ice size

selection button on the

control pad.

7

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 39 40

Comments to this Manuals

No comments