Danby DKC055D1SSPRO Owner's Manual download pdf (Page 5)

LOCATION

• Two people should be used when moving the

appliance.

• Remove interior and exterior packaging prior to

installation. Wipe the outside of the appliance

with a soft, dry cloth and the inside with a

lukewarm wet cloth.

• Place the appliance on a ﬂ oor that is strong

enough to support it when it is fully loaded.

• Before connecting the appliance to a power

source, let it stand upright for approximately

6 hours. This will reduce the possibility of a

malfunction in the cooling system from handling

during transportation.

• This appliance is 23.4 inches (59.5 cm) wide by

38 inches (96.5 cm) high (when installed with

leveling legs and guard rail) by 27.8 inches

(70.6 cm) deep. Make sure that you leave

the minimum amount of space between the

appliance and all surrounding walls and vents.

• Casters are included with this appliance. If the

casters are installed, the height increases to 39.9

inches (101.4 cm).

• WARNING: To avoid hazard due to instability

of the appliance, it must be ﬁ xed in accordance

with the instructions.

• Keep ﬂ ammable material and vapors such as

gasoline away from the appliance. Only use

nonﬂ ammable cleaner.

• Do not overload the appliance.

AMBIENT TEMPERATURE LIMITS

Do not install this appliance in a location where

temperature will fall below 41°F (5°C) or rise above

109°F (43°C).

Operating the appliance in an ambient temperature

which is too cold can cause the compressor to turn

off for too long, causing the internal temperature,

possibly resulting in loss of contents.

For best performance, do not install the appliance

behind a cabinet door or block the front vent.

INSTALLATION INSTRUCTIONS

FRONT VENT

This appliance is front breathing. Do not block the

front air vent as this will result in high operating

temperatures, higher energy usage and possible

system overheating and failure.

LEVELING INSTRUCTIONS

There is one adjustable foot on the bottom of the

appliance that can be turned up or down to ensure

that the appliance is level.

1. Turn the leveling foot counter-clockwise as far as

it will go, until the top of the foot is touching the

bottom of the cabinet.

2. Slowly turn the leveling foot clockwise until the

appliance is level.

CASTER INSTALLATION

To reduce the risk of personal injury or property

damage, unplug the appliance and use two people

to complete the caster installation.

1. Place the appliance on its back. Protect the ﬂ oor

and the back of the appliance from damage by

laying the appliance on a towel or blanket.

2. Remove the three solid feet. Unscrew the leveling

foot. Keep the solid feet and the leveling foot in

a safe place for future use.

3. Install the non-locking casters on the back of the

appliance.

4. Install the locking casters on the front of the

appliance.

Note: Once caster installation is complete, the

appliance must be allowed to stand upright for

6 hours before plugging in to avoid damage to

internal components.

1 2 3 4 5 6 7 8 9 10 ... 43 44

Comments to this Manuals

No comments

Danby DKC055D1SSPRO Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Fridges Danby DKC055D1SSPRO