13
PROBLEM POSSIBLE CAUSE
No power • A fuse may be blown or the circuit breaker tripped
• Plug not fully inserted into the wall outlet
Internal temperature not cold
enough
Appliance runs continuously
Alarm sounding and “HI” on
the display panel
• Door is not shut properly or opened excessively
• Exhaust vent is obstructed
• Ambient temperature or humidity is very high
• Possible system leak, evaporator fan failure or compressor failure
Alarm sounding and “LO” or
“CL” on the display panel
• Ambient temperature is excessively low
• Sensor failure
Excessive beer foam • Ensure the beer line hose from the tower and the CO
2
air line hose
from the CO
2
regulator are attached to the correct connections on
the coupler; beer line to the top of the coupler, CO
2
air line to the
side of the coupler
• Check that there are no leaks in any connections
• Ensure that the reed valve in the CO
2
connection at the coupler has a
hole in it
• The CO
2
pressure may be set too high; try turning the pressure down
• Ensure that the valve spool plastic rod is inserted into the coupler
Weak beer fl ow • Ensure the beer line hose from the tower and the CO
2
air line hose
from the CO
2
regulator are attached to the correct connections on
the coupler; beer line to the top of the coupler, CO
2
air line to the
side of the coupler
• Check that there are no leaks in any connections
• Ensure that the reed valve in the CO
2
connection at the coupler has a
hole in it
• The CO
2
pressure may be set too low; try turning the pressure up
• Ensure there are no bends or kinks in any of the hoses that could
impede fl ow
Silhouette Consumer Care: 1-844-455-6097
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Information in this manual is subject to change without notice.
TROUBLESHOOTING
Comments to this Manuals