Danby DKC055D1SSPRO Owner's Manual download pdf (Page 10)

INSTALLATION INSTRUCTIONS

1. Pressure Regulator

2. C0

Tank

3. Colored CO

Air

Line Hose

4. Faucet Assembly

5. Faucet Tower

6. Clear Hose with

Wing Nut

7. American Sankey

Coupler

8. Keg

Opening the CO

Cylinder Main Valve

To begin the ﬂ ow of CO

, turn the valve on the

top of the Co

cylinder. The pressure gauge on the

regulator will begin to climb.

Turn the CO

shut off valve on the regulator to the

open position to allow CO

to travel through the air

line and into the coupler.

Adjusting the CO

Regulator

The pressure gauge monitors the air pressure inside

the lines and should be adjusted to read between

8-12 PSI.

The pressure can be adjusted at any time, as

needed. If the beer is very foamy, try turning the PSI

down. If the ﬂ ow of beer is very weak, try turning

the PSI up.

After making any adjustment to the PSI, wait 5-10

minutes before attempting to pour another beer to

allow the pressure inside the lines to equalize.

• To increase the PSI, turn the adjustment screw

clockwise.

• To decrease the PSI, turn the adjustment screw

counter-clockwise.

Checking Connections For Leaks

Weak connection points can allow the escape of

or allow air into the system, both of which can

cause weak beer ﬂ ow or excessively foamy beer.

Leaking connections can sometimes be identiﬁ ed by

hissing at the connection points. They can also be

identiﬁ ed by spraying water on the connection point

and watching for bubbles to form.

If a leaking connection point is found, it should be

rectiﬁ ed before attempting to use the system again.

Turn off the ﬂ ow of CO

and replace any gaskets

or washers in the connection points. Tighten all nuts

with a wrench. Test the system again before using to

ensure all connection points are secure.

CONVERTING TO A REFRIGERATOR

This appliance can be converted to a refrigerator if

desired.

1. Disconnect and remove the keg, the coupler,

the regulator and the CO

cylinder from the

refrigerator cabinet.

2. Remove the faucet tower, the guard rails and the

drip tray from the top of the refrigerator cabinet.

3. Replace the cover for the opening on top of the

refrigerator cabinet.

4. Install the provided wire shelves in the

refrigerator cabinet.

5. Set the control panel to the desired temperature.

Allow the appliance to remain empty for a

minimum of two hours before stocking with

food or beverage items to ensure it reaches the

desired temperature.

Completed Assembly

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Comments to this Manuals

No comments

Danby DKC055D1SSPRO Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Fridges Danby DKC055D1SSPRO