Danby DHCC6020 Owner's Manual download pdf (Page 12)

Instructions de fonctionnement

Identification des

pièces

Operating Instructions

Humidifier

MODE

The operating mode can be defined when the unit is ‘On’ or

in ‘Standby’. The following steps are provided assuming the

unit is in standby mode.

1) Open the upper rear panel and locate the internal reser-

voir fill cap. Proceed to remove the fill cap (fig E.) from the

reservoir.

2) Slowly fill the internal water reservoir with fresh clean

water until the Water Level Display illuminates all four status

bars to signify the tank is full (as shown in Fig G).

3) Replace the fill cap and close the upper rear panel. If you

have removed the water tank during the fill process ensure

that the handle on the internal reservoir has been returned

to it’s original position - flat against the bucket.

4) Depress the ‘Mode’ button on the control panel until the

Humidifier icon is displayed in the LCD screen (Fig H).

5) Select the desired humidity level from 35% RH ~ 80% RH

by depressing either the increase (

) or decrease ()but-

tons on the control panel. To select

continuous

as the mode

of operation in lieu of defining a precise humidity level, press

the increase or decrease button until see the “

- - “ in the

set humidity display portion of the LCD, as shown in Fig. I.

6) Depress the power button to start the unit in Humidifier

mode at your specified settings.

Please note: During the Humidifier mode, the fan speed

cannot be changed.

ODE

Full

RH%

ºF

ºC

RH%

Fig E

Fig G

Fig H

Fig I

Fill Cap

1. Panneau Supérieure

2. Panneau De Commande Électronique

3. Poignée

4. Panneau de façade (amovible)

5. Roulettes

6. Réservoir Interne

7. Poignée Du Réservoir Interne

8. Bouchon de remplissage

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Danby DHCC6020 Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Dehumidifiers Danby DHCC6020