Danby DDR45A3GDB User Manual download pdf (Page 8)

NOTE: The control panel of the unit you purchased may be slightly different depending on the model number.

When you push the button to change operation modes, the unit will make a beeping sound to indicate that it is

changing modes.

1) POWER BUTTON: On/Off

2) FAN SPEED BUTTON: High/ Low

3) TIMER BUTTON: When the unit is operating, press

TIMER to set the number of hours desired until the unit

will shut off. When the unit is in stand-by mode, press

TIMER to set the number of hours desired until the unit

will turn on. Set the timer from 1-24 hours. To cancel the

timer, proceed as above, but set the “timer off” to zero (0)

hours.

4) º C/ º F BUTTON: Press the º C/ º F button to toggle

between degrees Celsius and Fahrenheit.

5) SET HUMIDITY/ CURRENT HUMIDITY DISPLAY:

When the unit is running, it displays the current humidity.

Press the UP or DOWN buttons to select the humidity

setting. The humidity is adjusted in increments of 5% by

each press of the button. The adjustable range is within

30% RH to 90% RH. 10 seconds after setting the humidity,

the display will change back to the current humidity.

6) CURRENT TEMP/ TIMER SET DISPLAY:

When the unit is running, it displays the current tempera-

ture. Press the TIMER button to set the machine to shut off

automatically after a speciﬁ ed amount of time. 10 seconds

after displaying the timer, the display will change back to

showing the current temperature.

7) DEFROST LIGHT: When the temperature is low, the

unit enters defrost mode, and the defrost light illuminates.

8) BUCKET FULL LIGHT

When the water tank is full, the bucket full light illuminates.

OPERATING INSTRUCTIONS

CONTROL PANEL INSTRUCTIONS

CASTOR INSTALLATION

Castor installation is recommended to avoid damage to ﬂ oors.

1. Remove the castors from the bucket of the dehumidiﬁ er.

2. Position the dehumidiﬁ er on its side.

3. Locate the arrow on the bottom of the dehumidiﬁ er and insert the castor

according to the arrow direction.

4. Slide the castor in as far as it will go. The castor will snap into place.

5. Repeat steps 1 to 4 for the other 3 castors.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

No comments

Danby DDR45A3GDB User Manual Page 8