Danby DAC14004D User Manual download pdf (Page 10)

E-

Removing Excess Humidity

If the atmosphere in your room is very humid or damp, you can remove

excess humidity without lowering the room temperature too much.

1 If necessary, press the (On/Off) button.

Result: The air conditioner starts up in the Cool mode.

The unit beeps.

The air conditioner is fitted with a protection mechanism to pre-

vent the unit from being damaged when it is started immediately

after being:

Plugged in

Stopped

It will start up normally after three minutes.

2 If the

temperature

is not displayed at the top of the control panel, press

the button on the control panel one or more times until it

appears.

Result

The unit beeps each time you press the button.

The air conditioner runs in Dry mode.

You can change modes at any time.

3 To adjust the temperature, press the

buttons one or

more times until the required temperature is displayed.

Possible temperatures are between

18 C and 30 C

inclusive.

Result: Each time you press the

buttons:

- The temperature is adjusted by 1 C

- The unit beeps

The air conditioner starts removing the excess humidity;

the quantity of air is adjusted automatically.

4 To control the direction of the air flow, refer to page 11.

Mode

Cool/Dry/Fan

Mode

Cool/Dry/Fan

Remote Control

Control Panel

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 57 58

No comments

Danby DAC14004D User Manual Page 10