Danby DBC162BLSST Owner's Manual download pdf (Page 7)

Operating Instructions

Setting the

Temperature

When you plug in your bever-

age center for the first time,

the temperatures will auto-

matically be set to 54°F

(12°C) and will be displayed

in the Fahrenheit scale (°F).

• To switch the display

between the Fahrenheit (°F)

and Celsius (°C) scale,

depress the and

control buttons simultaneou-

sly for approximately 3 seconds.

be set as low as 39°F(4°C)

or as high as 64°F (18°C) to

suit your specific storage

sion of the or but-

ton will allow you adjust the

temperature in 1° degree

increments within the afore-

mentioned range.

The Controls of your

Beverage Center

Indicator light illuminates to signify the

cooling mode is currently in operation.

2. ‘ ’ Button

To control this appliance turn ON/OFF

( press and hold this buttons for

approximately 3 seconds).

3. ‘ ’ Button

lamp swith and keep lighting.)

4. °C / °F

Adjacent indicator light denotes which

scale of temperature is displayed.

5. ‘

’

Button

Used to raise (warmer) the temperature

in 1° degree increments.

‘

’

Button

Used to decrease (cooler) the

temperature in 1° degree increments.

°C

°F

Function

Instructions

NOTE !

To control the inner light turn ON/OFF

• The temperature range can

requirements. Each depres-

If too many bottles/cans are put in at

once or the door has not been

closed tightly, the unit will display the

is normal please wait 5 minutes

after you close the door and

“HI” will disappear.

It is normal that the cabinet

shows “HI” or “LO” from time to time,

If it occurs frequently or lasts for a

long time, you can restart the unit by

unplugging it. If the problem

occurs once again after restart,

please contact the customer service.

previous temperature settings, and when the power is restored the

cabinet temperature will go back to the same setting temperature as

before.

If inner temperature is higher than 74°F(23°C), “HI” is shown

in the display panel, and the alarm will sound after one hour.

It informs you that the inner temperature is too high, please

check the reason. If inner temperature is lower than 34°F(1°C),

“LO” is shown in the display panel and the alarm will turn on.

In the event of a power interruption the Beverage Center can remember the

• TTemperature Memory Functionemperature Memory Function

If the door is not closed completely the alarm will sound after 5 minutes.

• Door Ajar Alarm Function

• TTemperature Alarm Functionemperature Alarm Function

(If this button is pressed, the inner light is

not controled by the extrusion-board of

"HI" signal in the display panel. This

Please close the door completely to avoid the loss of cold energy.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Comments to this Manuals

No comments

Danby DBC162BLSST Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Wine coolers Danby DBC162BLSST