Danby DOAR154SSST Use and Care Manual download pdf (Page 8)

OPERATING INSTRUCTIONS

Please use the appliance between 41-90°F (5-32°C) ambient temperature. If the ambient temperature is

higher than or lower than this temperature it will cause temperature fluctuation in the cabinet.

CONTROL PANEL

INSTRUCTIONS

Indicator light illuminates to signify the cooling mode

is currently in operation.

Control the interior light ON/OFF.

To turn appliance on/off (press and hold this button

for approximately 3 seconds).

Used to raise(warm) the temperature by 1°

increments.

Used to lower (cool) the temperature by 1°

increments.

(°C / °F) Adjacent indicator light denotes which scale of

temperature is displayed.

SETTING THE TEMPERATURE

CONTROLS

• The temperature range can be set as low as 36 °F

(2°C) or as high as 50°F (10°C) to suit your specific

storage requirements. Each depression of the

buttons will allow you adjust the temperature in 1°

increments within the aforementioned range.

• To switch the display between the Fahrenheit (°F) and

Celsius (°C) scale, depress the

simultaneously for approximately 3-5 seconds.

buttons

Temperature Memory Function

• If power is lost the set temperature will be saved by the

unit. Once the power is back on the unit will return to the

same set temperature.

Door Ajar Function

• If door is not fully closed, there will be a warning alarm

after 5 minutes.

Temperature Alarm Function

• If inner temperature is higher than 73°F (23°C), “HI” is

shown in display panel and the alarm will sound after

one hour. It is to inform you that the inner temperature is

too high, please check the reason.

• If inner temperature is lower than 34°F (1°C), “LO” is

shown in display panel and the alarm will sound and the

malfunction indicator light will appear at the same time.

FUNCTIONS

IMPORTANT!

Do not cover the gap on the glass shelves with alu-

minum foil or any other material that will prevent ade-

quate air circulation within the cabinet.

SHELVES

When removing any of these shelves out of the rail com-

partment, you must first disassemble and remove the

plastic posts then remove the Lock screws that hold each

post in place.(Fig A)

To re-install, ensure the shelf is resting securely on the

support brackets and push shelf inward until it locks into

place.

Fig A.

Lock

Screws

Plastic

Posts

Gaps

When you plug in your refrigerator for the first time the

temperature will automatically be set to 41 °F (5°C) and

will be displayed in the Fahrenheit scale (°F). (Default

setting)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 22 23

Comments to this Manuals

No comments

Danby DOAR154SSST Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Unknown Danby DOAR154SSST