Danby DPAC7008 Owner's Manual download pdf (Page 4)

The power cord supplied with this air conditioner

contains a current leakage detection device

designed to reduce the risk of fire. Please refer to

the section "Power Supply Cord" for details. In the

event the power supply cord is damaged, it cannot

be repaired it must be replaced with a new cord

from the Product Manufacturer.

• Under no circumstances should this device be

used to turn the air conditioner on or off.

• The ‘RESET’ button must always be pushed in

(engaged) for correct operation.

• The power supply cord must be replaced if it fails

to reset when the ‘TEST’ button is pushed in.

• If the power supply cord is damaged, it cannot

be repaired. It must be replaced with a new cord

obtained from the Product Manufacturer.

Important Safety Instructions

Electrical Specifications

1. Check available power supply and resolve any

wiring problems BEFORE installation and opera-

tion of this unit. All wiring must comply with local

and national electrical codes and be installed by

a qualified electrician. If you have any questions

regarding the following instructions, contact a

qualified electrician.

2. This appliance draws 6.5 nameplate amps under

Cooling Mode and may be used in any properly

wired, general purpose 15 amp household

grounded receptacle.

3. For your safety and protection, this unit is

grounded through the power cord plug when

plugged into a matching wall outlet. If you are

not sure whether the wall outlets in your home

are properly grounded, please consult a qualified

electrician.

4. DO NOT USE PLUG ADAPTERS OR REGULAR

EXTENSION CORDS WITH THIS UNIT. If it is

necessary to use an extension cord with this

unit, use an approved “air conditioner” extension

cord only (available at most hardware stores).

5. To avoid the possibility of personal injury, always

disconnect the power supply to the unit, before

installing and/or servicing.

Table 1

Suggested Individual Branch Circuit

Nameplate Amps AWG Wire Size*

6.5 14

AWG- American Wire Gage

* Based on copper wire at 60°C temperature rating.

Table 2

Receptacle and Fuse Types

Rated Volts 125

Amps 15

Wall Outlet

Fuse Size 15

Time Delay Fuse Plug Type

(or circuit breaker)

The power cord supplied with this air conditioner

contains a device that senses damage to the power

cord. To test if your power supply cord is working

properly, you must do the following;

1. Connect the power supply cord to an electrical

outlet.

2. The power supply cord is inclusive of two buttons

located on the head of the plug. One button is

marked ‘TEST’, the other button is marked

‘RESET’. Press the ‘TEST’ button, you will hear a

click as the ‘RESET’ button pops out.

3. Press the ‘RESET’ button, you will hear a click as

the button engages.

4. The power supply cord is now energized and

supplying electricity to the air conditioner. (On

some products this is also indicated by a light on

the plug head).

CAUTION

Do not leave this unit unattended in a space

where people or animals who cannot react to a

failed unit are located. A failed unit can cause

extreme overheating or death in such an

enclosed, unattended space.

Power Supply Cord

WARNING!

Improper connection of the ground-

ing plug can result in a risk of; Fire, Electric

Shock and/or Injury to Persons associated with

the Appliance.

Check with a qualified electrician

or service representative if you are in doubt that

the appliance is properly grounded.

1 2 3 4 5 6 7 8 9 ... 27 28

Comments to this Manuals

No comments

Danby DPAC7008 Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Split-system air conditioners Danby DPAC7008