Danby DPAC7008 Owner's Manual download pdf (Page 12)

Remote Control Instructions

Control Buttons

1) Power Switch

2) Mode

3) Fan Speed

4) Used to increase or decrease the temperature to

select a suitable operating temperature setting.

5) Lock: Prevents the remote control settings from

being inadvertently being changed.

6) Restore remote control default settings.

7) TIMER-ON: Used to initiate the AUTO-ON (start)

timer and adjust Timer On settings

forward

(0.5/1h)

8) TIMER-OFF: Used to initiate the AUTO-OFF

(stop) timer and adjust Timer Off settings

forward

(0.5/1h)

To operate the hand held remote control will require

two “AAA” Alkaline batteries (included).

Batteries should be replaced when:

a) No signal (beep) is heard when attempting to

program the main unit.

b) The main unit does not respond to a command

issued by the remote.

Battery replacement:

1. Slide the rear cover on the remote in the general

direction of the arrow. Continue pulling (gently) until

the cover seperates completely from the unit.

2. Insert (2) batteries (AAA) following the same ori-

entation (polarity) depicted inside the battery cham-

ber (+/-).

3. Re-install rear cover.

4. If the remote control will not be used for extend-

ed periods of time (vacations, etc.), batteries should

be removed.

The remote operates within a range of 8 meters

(26 ft.) from the receiver located inside the main

unit. Any obstruction between the receiver and

remote may cause signal interference, limiting the

ability to program the main unit.

Note:

• Remote sets/shows °C only.

TEMP.(°C)

Electronic

Display

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Comments to this Manuals

No comments

Danby DPAC7008 Owner's Manual Page 12

Comments to this Manuals

Related products and manuals for Split-system air conditioners Danby DPAC7008