Danby DPA110B2WDD Specifications download pdf (Page 3)

Use the remote control within a distance of 8

meters from the appliance, pointing it towards the

receiver. Reception is confirmed by a beep.

Location of the Remote Control.

CAUTIONS

The air condiitioner will not respond if curtains, doors or other materials

block the signal from the remote control to the unit.

esopxe ton oD .lortnoc etomer eht htiw tcatnoc morf diuqil yna tneverP

the remote control to direct sunlight or heat.

If the infrared signal receiver on the indoor unit is exposed to direct

sunlight, the air conditioner may not function properly. Use curtains to

prevent the sunlight from falling on the receiver.

If other electrical appliances react to the remote control, either move

these appliances to another location or consult your local dealer..

The remote control is powered by two dry

part and protected by a cover.

(1) Remove the cover by pressing down and sliding it off.

(2) Remove the old batteries and insert the new

batteries,placing the(+) and (-) ends correctly.

(3) Reattach the cover by sliding it back into

position.

NOTE: When the batteries are removed, the

remote control erases all programming.

After inserting new batteries, the remote

controll must be reprogrammed.

Replacing the Batteries

Handling the Remote Control

batteries(2-AAA) located in the rear

1 2 3 4 5 6 7 8 ... 27 28

No comments

Danby DPA110B2WDD Specifications Page 3