Danby DAC15009EE Operations Instructions download pdf (Page 16)

INSTALLATION INSTRUCTIONS

Install Support Bracket

1) Hold each support bracket flush against outside of sill, and tighten to bottom of cabinet as shown in Fig. J1. Mark

brackets at top level of sill, and remove.

2) Assemble sill anchor bracket to outside support legs at the market positon, as seen in Fig. J2. Hand tighten, but allow

3) Install support brackets (with sill anchor brackets attached) to correct hole in bottom of cabinet

as shown in Fig. K.

4) Tighten all 6 bolts securely.

Mark

Fig. J1

Left

Locknut

Sill Anchor

Bracket

Flat Head

Bolt

2 Each Required For

Each Support Bracket

Right

1/2in.(12.7mm) Long

Left Screws And

Locknuts

Fig. J2

Fig. K

Extend Window Filler Panels

Install Window Lock and Sash Seal

1) Trim sash seal to fit window width. Insert into space between upper and lower sashes (Fig. M).

2) Attach right angle safety lock as shown in Fig. M.

Install Chassis into Cabinet and Install Front to Unit

1) Lift chassis and carefully slide into cabinet, leaving 6 inches protruding.

2) DO NOT push on controls or coils.

3) Be sure the chassis is firmly seated towards rear of cabinet.

4) Installation of front is the reverse of removal, outlined in section 1(“Remove Chassis”).

Safety Lock

1/2” screw

Window

Sash Seal

Fig.M

for any changes later. NOTE: Check that air conditioner is tilted downwards to the outside, about 3° to 4°, as shown in Fig. I.

Window Sill

Window Sash

About 1¼ " to 1⅝"

Sill Angle Bracket

Side Louvers

Fig. I

locking screw &

flat washer.

13/16in.(20mm) Screw & Frame Lock (2)

Fig.L

1) Extend panels to fill window opening completely. Secure the shutter clamp on each side of the (upper) shutter and

secure to window sill using one 7/16in.(12mm) locking screw & flat washer on each side. (Fig.L)

2) Attach frame lock to window sill using one 13/16in. (20mm) screw on each side as shown in Fig. L.

3) Close window behind “L” bracket as seen in Fig. L.

7/16in.(12mm)

After proper installation, condensed water should not drain from the overflow drain hole during normal use. If you notice

water leaking out , check the angle of tilt, and make any necessary adjustments. However, on a very humid day, water

leakage can occur – this is normal. Measure the tilt angle from the cabinet’s edge. The distance H should be approximately

1 1/4” to 1 5/8”.

Measure

the tilt

angle from

the cabinet’s

edge.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Danby DAC15009EE Operations Instructions Page 16

Comments to this Manuals

Related products and manuals for Split-system air conditioners Danby DAC15009EE