Danby DPF073C1WDB Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Try not to open the door too often, especially when the weather is hot and humid. Once you open the door, close it as
soon as possible.
Every now and then check if the appliance is suf ciently ventilated (adequate air circulation behind the appliance).
Set the thermostat from cooler to warmer settings whenever possible (depending on how loaded the appliance is,
ambient temperatures etc.).
Before loading the appliance with packages of hot food, make sure that they are cooled to ambient temperature.
Ice and frost layers increase energy consumption, so defrost the appliance as soon as the frost layer is 1/4 inch / 3-5
mm thick.
If the gasket is damaged or the door seal is poor, energy consumption is substantially higher. To restore ef ciency,
replace the gasket.
Always follow instructions stated in this manual.
ENERGY SAVING TIPS
The refrigerator system of the appliance is lled with refrigerant and insulating substances which should be separately
treated and processed. Call your nearest authorized service agent or specialized servicing centre. If you are unable to
locate one, contact your local authorities or your distributor. Be careful not to damage the tubes on the rear wall of the
appliance.
DISPOSING OF YOUR OLD APPLIANCE
SAVE THESE INSTRUCTIONS!
To avoid vibration, the unit must be set level. This is accomplished by adjusting the front leveling leg, located under
the refrigerator.
Before connecting this appliance to electrical power supply, leave it to stand for approximately 24 hours, which will
reduce the possibility of malfunction in the cooling system due to transport handling.
This unit is not designed for outside installation, including installation anywhere that is not temperature controlled
(including garages, porches, carports, etc.).
If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before restarting the unit. If you
attempt to restart before this time delay, the refrigerator-freezer will not start.
BEFORE STARTING
3
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 39 40

Comments to this Manuals

No comments