Danby DCR032C1BDB Manual download pdf (Page 8)

The temperature of the refrigerator can be

adjusted by turning the thermostatic dial. The

range of temperature controls is from position

“OFF,” or NO COOLING to “7”, the coldest.

The setting of “4” should be satisfactory for

home refrigerator use.

Operating Instructions

TEMPERATURE

SELECTION

To avoid vibration, the unit must be on a level surface. This is

accomplished by adjusting the leveling legs located under the refrigerator.

The temperature of the refrigerator is controlled by setting the thermostat

knob to a desired setting.

BEFORE USING

Before the refrigerator is plugged in make sure the electric voltage to1

be used is the same as the rated voltage. The power plug should

have its own independent socket. Using an adapter may cause the

socket to overheat.

Do not store flammable materials such as ether, benzene, LP gas2

and glue, etc. in the refrigerator.

Do not splash water on the refrigerator, it may cause a malfunction or3

electric shock.

The first time you turn the unit on, set the temperature control to “7,”4

the coolest setting. Run the refrigerator without loading any food for at

least 2 hours. This ensures that the compartment has cooled down

sufficiently before placing any food inside.

Defrost the freezer compartment whenever the layer of frost on the surface

of the evaporator reaches 3 or 4 mm. When defrosting, remove all food and

set the thermostat to the “OFF” position. Put the drip tray under the evapora-

tor to collect melted water. After the frost has melted, discard the melted

water and dry up the interior of refrigerator. The refrigerator can then be

restarted by turning its thermostat to the desired setting.

Note: Never use sharp or pointed instruments to remove ice from the freezer

compartment. The freezer compartment contains refrigerated gas lines and if

accidentally punched/pierced, will render the refrigerator inoperable and void

the manufacturers warranty.

DO NOT ALLOW THE REFRIGERATOR TO CONTINUE OPERATION IF

THE FREEZER COMPARTMENT IS PIERCED.

After defrosting is complete, set the control to maximum for 2 to 3 hours

before returning to the desired position. When the refrigerator is not to be

used for a long period of time, disconnect the appliance from the electrical

supply and leave the door partially open. This will help to reduce mold and

mildew build-up.

Note: Wait 3 to 5 minutes before attempting to restart the refrigerator if oper-

ation has been interrupted.

DEFROSTING

ICE CUBE TRAY

The ice cube tray is flexible. Twist tray to remove the ice cubes. If the ice cube

tray is frozen solid to the evaporator surface, run a little water over the tray.

Never use a knife or other metal instruments to remove the ice cube tray, as this

may damage the evaporator.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Comments to this Manuals

No comments

Danby DCR032C1BDB Manual Page 8

Comments to this Manuals

Related products and manuals for Fridges Danby DCR032C1BDB