Danby DCFM99WDD User Manual download pdf (Page 6)

CARE AND MAINTENANCE

Moisture will be introduced to the liner during lid openings and

the addition of unfrozen food packages. The moisture will accu-

mulate in the form of frost, mostly on the upper part of the liner

walls. Accumulation of frost up to 6 mm (1/4") on the liner is not

harmful. However, when it becomes heavier, it should be

removed as it slows cooling, resulting in longer running (cycle)

times. Under average conditions, defrosting will not be neces-

sary more than once or twice a year. Besides frost, food parti-

cles and other foreign substances may accumulate and soil the

liner.

For proper defrosting and cleaning, the following method is

recommended:

a) Unplug freezer.

b) Quickly remove all frozen food and store in baskets, cartons

or other suitable containers. Keep food well covered with

blankets to avoid excessive temperature rise.

c) A kettle/pot of hot water placed in the center of the cabinet

will greatly accelerate defrosting.

d) With the help of a wooden spatula or a plastic defrosting

scoop, remove the frost and ice off the liner walls as soon

as it becomes loose (approximately 15 minutes from start) -

do not use any sharp instruments as this may result in

damage to the liner wall and/or sealed system, voiding any

and/or all warranties which may be in effect. Using a piece

of cloth soaked in hot water, the process can be

considerably accelerated. As soon as the ice has fallen to

the bottom, remove it. Do not let it melt in the freezer as

this will increase defrosting and cleaning time.

DEFROSTING

Now the liner is ready to be cleaned. Sprinkle baking soda on

the bottom and walls. This will help in cleaning and odor

removal. In order to retain the finish of the freezer cabinet

inside and outside, wash only with warm water and mild

soap, then rinse and dry. Do not under any circumstances

use a gritty soap or a kitchen scouring cleanser, as these

tend to scratch the finish.

CLEANING

In the event of a general power failure, it is important to keep

the contents of your freezer frozen. For your protection, it is

recommended to locate a dealer of dry ice (solidified carbon

dioxide) as soon as possible in order to know where to go in

case of an emergency. Many ice cream manufacturers use

dry ice and this will keep the contents of your freezer at safe

temperatures until the emergency has passed.

In case of failure, it is recommended to keep the freezer well

covered with blankets. This will help preserve the “cold”

inside the freezer. If no help is available within 12 hours, the

freezer contents should be transferred into a neighbors freez-

er (if available).

In the event of mechanical or electrical failure of the freezer,

contact a service agent immediately and give complete infor-

mation of your freezer, the model number and the serial num-

ber. These are shown on the serial plate located on the exte-

rior (rear) cabinet wall.

ELECTRICAL AND MECHANICAL

FAILURE

VACATION TIME

For short vacation periods, leave the control knob at its nor-

mal setting. During longer absences,

(a) remove all foods.

(b) disconnect power cord from electrical outlet.

(d) leave lid open to avoid possible formations of conden-

sate, mold or odors.

POWER FAILURE

Most power failures are corrected within an hour or two and

will not affect your freezer temperatures. However, you

should minimize the number of lid openings while the power

is off. During power failures of longer duration, take steps to

protect your food by placing dry ice on top of packages.

IF YOU MOVE

Remove or securely fasten down all loose items inside the

unit. To avoid damaging the leveling legs, turn them all the

way into the base.

SOME IMPORTANT RULES FOR THE CORRECT USE

OF THE FREEZER

• Never place hot foods in the freezer.

• Never place spoiled foods in the unit.

• Don’t overload the unit.

• Don’t open the lid unless necessary.

• Should the freezer be stored without use for long peri-

ods, it is suggested, after a careful cleaning, to leave

the lid open to allow the air to circulate inside the unit in

order to avoid the possibility of condensation, mold or

odors.

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Comments to this Manuals

No comments

Danby DCFM99WDD User Manual Page 6

Comments to this Manuals