Danby DCFM99WDD User Manual download pdf (Page 5)

INSTALLATION INSTRUCTIONS

FEATURES

1) Front Mounted Thermostat: Easily accessible control

knob controls the desired temperature inside the freezer.

The proper food storage temperature is -18°C (0°F). The

thermostat engages the motor when the temperature rises

above the set temperature.

2) Defrost Drain: For easy removal of melted ice during

defrosting. It is recommended that you defrost your

freezer once or twice a year.

3) Rust Resistant Interior (not shown): Aluminum liner for

long lasting durability.

3.5 cu. ft. (100L)

IN-WALL CONDENSER:

Helps reduce ice build-up.

OPERATING INSTRUCTIONS

The freezer is ready to operate as received, when connected to

the power supply. After connecting to power supply, close lid

and allow freezer to operate. The unit will run from 1 to 2 hours

(possibly longer, depending on conditions) before operating

temperature is reached. It will then start and stop (cycle) at fairly

regular intervals. It is recommended that food not be placed in

the freezer until you are satisfied that it is operating (cycling)

regularly and no final adjustments are necessary.

Once your freezer is starting and stopping (cycling) regularly, it

is ready to freeze and store foods. The proper food storage tem-

perature is -18°C (0°F). Do not operate freezer at temperatures

below -19°C (-3°F), as this does not improve food preservation

and only results in longer unit (cycle) running time. It is not

advisable to freeze more than 25 kg.(50 lbs.) of food in any 24

hour period. It will take 15 or more hours of unit running time to

freeze this amount of food.

When adding fresh, unfrozen food packages, store them against

the walls. The sensing bulb of the thermostat is fastened to the

liner wall on the “insulation side” of the freezer. In view of the

value of the contents of your freezer, it is advisable to inspect

contents and check freezer operation regularly.

STARTING THE FREEZER

TEMPERATURE CONTROL

The control has been set at the factory for proper operating

temperature. Should it be necessary to lower or raise the unit

temperature, it should be noted that turning the knob to the

right (clockwise) will lower the cabinet temperature (cooler).

Turning the knob to the left (counter-clockwise) will raise it

(warmer). Higher numbers on the thermostat knob indicate

colder temperatures.

• If the thermostat is turned to the extreme left, until it “clicks”

(OFF position), then the power to the unit is switched off.

• The recommended control setting is in the middle of the

control knob.

1 2 3 4 5 6 7 8 9 10 ... 20 21

Comments to this Manuals

No comments

Danby DCFM99WDD User Manual Page 5

Comments to this Manuals