Danby DWC018A1BDB User Manual download pdf (Page 9)

Operating Instructions

SETTING THE TEMPERATURE

The temperature of the wine cooler is controlled by adjusting the thermostat control knob on the back

of the unit. To achieve maximum cooling temperature quickly:

• Turn the temperature control knob clockwise to the widest, darkest part of the graduated blue

control dial.

• Allow the unit to run at this setting for 3 - 4 hours.

• When maximum cooling is achieved, turn the temperature control knob to the middle position on

the graduated blue control dial, as per Fig. A.

• To turn the wine cooler off, turn the control knob to the “0” position, as per Fig. B. If the wine cooler

will not be used for an extended period of time, it is recommended to unplug the unit and leave the

door partially open to avoid possible formation of odors inside the unit.

Note: Wait 3 - 5 minutes before restarting the unit if operation has been interrupted.

Note: On the graduated blue dial, the thicker, darker blue indicates colder temperatures and the

thinner, lighter blue indicates warmer temperatures. The wine cooler temperature will vary depending

on the quantity of bottles stored in the unit and the frequency that the door is opened.

INTERIOR LIGHT

To manually operate the interior light, press the light switch situated on the right side of the interior

light housing on the ceiling of the unit. This will allow the light to remain on while the door is closed.

Note: The light will default to off. It can be turned on to run continually. Due to energy efﬁ ciency

requirements for a wine cooler in this size, there is no option to have the light turn on when the door

opens.

DEFROST

This unit is equipped with an automatic defrost function and does not require manual defrosting.

Defrost water from the unit is channeled into a drip tray located above the compressor. Heat transfer

from the compressor causes the defrost water to evaporate.

SHELF INSTRUCTIONS

To remove a shelf from its locked position, lift the rear of the shelf

upward and then slide the shelf out of the unit.

To replace the shelf, ensure it is resting securely on the support

brackets and then push inward until the shelf locks into place.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

No comments

Danby DWC018A1BDB User Manual Page 9