Danby DWC047D1BSSPR Owner's Manual Page 11

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 10
9
Setting the Temperature Controls
When you plug in your wine cooler for the rst time the temperature will automatically be set to 12°C
(54°F). The default setting is °F.
The temperature can be set as low as 5°C (41°F) or as high as 18°C (64°F) to suit your speci c
storage requirements. Each depression of the
or
button will allow you to adjust the tempera-
ture in 1° increments within the aforementioned range.
To switch the display between °F and °C, depress the
and
simultaneously for approximately
3-5 seconds.
Operating Instructions
FUNCTION INSTRUCTION
Door Ajar Alarm Function
The door ajar alarm will sound if the door is left open for more than 5 minutes. Ensure that the
door is completely closed to avoid the loss of cold energy.
If the door ajar alarm sounds and the door is completely closed, ensure that the rubber gasket on
the inside of the door is making a solid seal with the cabinet all the way around.
Temperature Memory Function
If power is lost, the set temperature will be saved by the unit. Once the power is back on the unit
will return to the same set temperature.
Temperature Alarm Function
If the inner temperature is higher than 23°C (73°F), “HI” is shown on the display panel and the
alarm will sound after one hour to alert you that the inner temperature is too high.
If the inner temperature is lower than 0°C (32°F), “LO” is shown on the display panel and the
alarm will sound.
If too many bottles/cans are put in at once or if the door has not been closed tightly, the unit
will display the “HI” signal in the display panel. This is normal, please wait 5 minutes after
you close the door and “HI” will disappear.
It is normal that the cabinet shows “HI” or “LO” from time to time. If it occurs frequently or
lasts for a long time, you can restart the unit by unplugging it. If the problem occurs once
again after restart, please contact customer service.
Page view 10
1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments