Danby DWC047D1BSSPR Owner's Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
4
FOR YOUR SAFETY
While performing installations described in this section, gloves and goggles or safety glasses
should be worn. Two people should be used when moving the wine cooler.
Remove interior and exterior packaging prior to installation.
Before connecting the appliance to a power source, let it stand upright for approximately 4 hours;
this will reduce the possibility of a malfunction in the cooling system from handling during transpor-
tation.
Place your wine cooler on a oor that is strong enough to support it when it is fully loaded. To level
your wine cooler, adjust the front leveling leg at the bottom of the unit.
Locate the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight and heat sources may increase electrical consumption. Extreme cold ambient tem-
peratures may also cause the unit to perform improperly.
Avoid locating the unit in moist areas.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions con-
cerning power and/or grounding should be directed toward a certi ed electrician or an authorized
service centre.
Do not cover shelves with aluminum foil or any other material which may prevent air circulation.
Do not open the door unless necessary.
Should the wine cooler be stored without use for long periods, it is suggested, after careful clean-
ing, to leave the door ajar. This will allow air to circulate inside the cabinet in order to avoid possi-
ble formations of condensation, mold and odors.
This appliance may tip when shelves are extended, possibly causing damage, injury or loss of
contents. If this appliance is being used in a free-standing application, the anti-tip bracket must be
installed.
If the power supply cord is damaged it must be replaced by the manufacturer, its service agent or
similarly quali ed person in order to avoid hazard.
SAVE THESE INSTRUCTIONS!
Important Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Risk of re or explosion due to puncturing of refrigerant tubing. Do not use sharp opjects to
aid in defrost. Please handle with care. Keep ammable materials and vapors such as gaso-
line away from the unit. Use non ammable cleaner.
Disposal of this unit should be in accordance with federal and local regulations.
IMPORTANT WARNING
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments