Danby DBD5L Owner's Manual download pdf (Page 18)

CARE AND CLEANING

CAUTION: DO NOT USE A DISHWASHER TO CLEAN THE BEVERAGE

DISPENSER, SPARE PARTS OR ACCESORIES.

NOTE: Handling beverages requires very special attention to cleanliness and

hygiene. Clean the beverage dispenser, spare parts, and accesories thoroughly

after each use.

CLEANING THE OUTSIDE OF THE BEVERAGE DISPENSER

Always unplug the beverage dispenser before cleaning. Do not use a hard brush or

sponge. Use a small amount of soap in water with a soft cloth. To dry, use a dry soft

cloth or towel.

Never immerse the beverage dispenser in water or other liquids. Do not let water or

liquid get into the casing of the unit. Never use very hot water.

Remember to rinse out the drip tray if it should be filled during use, and clean

thouroughly after each use.

CLEANING THE INSIDE OF THE BEVERAGE DISPENSER

Soak up all beverage or liquids that have spilled in the cooling compartment; Clean the

cooling compartment with soapy water and a soft cloth.

Clean and rinse the tap with a soft cloth and water

CLEANING THE SPARE PARTS AND ACCESORIES

Thoroughly clean all TUBES, ADAPTERS, and CONNECTORS with light soap and

warm water. For the ADAPTERS to be properly washed and rinsed, the

CONNECTORS and TUBES need to be attached. This will provide access to

inaccessible areas within the ADAPTERS. Make sure to remove the “O-rings” in the

ADAPTERS and CONNECTORS to clean inaccessible areas. Rinse thoroughly under

warm flowing water to remove any residual soap and beverage residue.

Repeat if necessary.

Air dry all washed parts and accessories for 24 hours.

NOTE: Do not pre-install the accessories. Store the accessories in a separate box or

bag outside of the beverage dispenser.

1 2 ... 13 14 15 16 17 18 19 20 21 22

No comments

Danby DBD5L Owner's Manual Page 18