Danby DKC445BL User Manual download pdf (Page 7)

CHILL'N TAP ASSEMBLY INSTRUCTIONS:

1. Remove Worktop: Using a Phillips Screwdriver, remove the

three screws located on the front underside edge of the

worktop and the three screws located at the rear (back)

side of the worktop.

See Fig's. 1 & 2

Remove the worktop from the cabinet and position the

worktop on top of the cabinet so that the front corners

are staggered across the front corners of the cabinet.

2. Installation of Top Rail: Attach the chrome rail to the work

top using four self-tapping screws from the underside of the

worktop through the pre-drilled holes. (attach the front ends

of the rail first)

3. Re-Install Wo r k t o p : Install the front of the worktop onto the

cabinet, then lower the rear side of the worktop over the

backside of the cabinet. Secure using the same screws

removed earlier. (the smaller screws at the front the larger

screws at the rear)

4. Installation of CO2 Cylinder Support: Install the cylinder

support onto the four studs located on the exterior back

wall of the cabinet. (no tools required) Align the holes in

the cylinder support with the studs and push down firmly.

See Fig. 3

5. Installation of CO2 Cylinder: Install your " fully charged"

CO2 cylinder into the support stand.

IMPORTANT NOTICE:

ALWAYS EXERCISE EXTREME CAUTION WHEN

HANDLING PRESSURIZED C02 CYLINDERS:

6. Installation of C02 Regulator: Attach the CO2 Regulator to

the C02 cylinder by screwing the regulator nut onto cylinder

valve and tighten (snug) using an adjustable wrench.

7. Installation of C02 Air Line Hose to Regulator: Attach one

end of the (red) air line hose to the hose barb connection

on the CO2 regulator. Secure hose by using one of the two

(self locking) black plastic snap on clamps provided.

(use pliers to snap the clamp tight to assure that there are

no leaks)

See Fig. 5

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments to this Manuals

No comments

Danby DKC445BL User Manual Page 7

Comments to this Manuals

Related products and manuals for Unknown Danby DKC445BL